Page is loading ...
1
KS200/202 Installation Guide
DFI reserves the right to change the specications at any time prior to the product's release. For the latest revision and for a
more details of the installation process, please refer to the user's manual on the website.
www.d.com
Note:
The CD that came with the system contains an autorun screen to install drivers, utilities,
and software applications required to enhance the performance of the system and a user's
manual for your reference. Insert the CD into a CD-ROM drive. The autorun screen will
appear. If after inserting the CD, “Autorun” did not automatically start, please go directly to
the root directory of the CD and double-click “Setup”. Please install all required drivers.
Package Contents
KS200 KS202
•
1 7" Touch Panel PC
•
1 Poron foam
•
1 24V power adapter
•
3 Terminal blocks
•
1 Quick Installation Guide
•
1 CD disk includes:
- Manual
2
Connecting Cables to Terminal Blocks
1. Insert the cable end of the power adaptor to the terminal block. To rmly x the cable into
the terminal block, use a screwdriver to clamp down the wires to the screw that is in the
terminal block.
Terminal block
Wire
Power adapter cable
2. Plug the terminal block into the DC-in connector and then tighten the screws to secure the
terminal block in place.
DC-in
connector
Screws
White Wire
Black Wire
+ -
3
Board Layout and Jumper Settings
COM 1
COM 2
Line-out
3
1
10
12
COM2 RS232/422/485 HW/SW Select(JP7)
SD/MMC
Reset
1
Amplifier 2W
Connector
1
2
19
20
LVDS LCD Panel
LED Connector (external)
USB 1-2
1
ON
2 3 4 5 6
Standby Power LED
LAN 1
1
ON
2 3 4 5 6
SW3
Touch
Connector
(default)
LVDS83B
1
14
DIO
1
5
Touch
Connector (option)
DC-in
SW4
Power SW
Battery
1
Clear CMOS(JP1)
1
1
1
AM3517AZCN
DDR2
DDR2
128M
Android Hot Key Connector
128M
USB 2514BI
AIC23B
SP338EER1
AVC
16T245
AVC
16T245
NAND Flash
DDR2
DDR2
128M
128M
TOP VIEW
BOTTOM VIEW
Clear CMOS Data JP1
Normal (default) 1-2 On
Clear CMOS Data 2-3 On
Boot Sequence (SW3)
MMC Boot 1-4 On, 2-3 Off
NAND Boot 1-4 Off
RS232/RS422/RS485 HW/SW Select: COM 2 (JP7)
Set via Software 1-4-7-10
2-5-8-11 On
Set via Hardware 2-5-8-11
3-6-9-12 On
RS232/RS422/RS485 Select: COM 2(SW4)
RS232 1 On, 2-3 Off
RS422 1-2 On, 3 Off
RS485 2 On, 1.3 Off
Note: If you use SW4 to select RS232/ RS422/ RS485, make
sure JP7 is set to “Set via Hardware”.
934-KS2000-0A0G
A23212304
/
