& 1500

ESAB & 1500, 1125, 1500, 875, Wheel Cart Powercut-650, Wheel Cart Powercut-650, 875, 1125, & 1500, Wheel kit for PowerCut 650, Wheel kit for PowerCut 650, 875, 1125, 1500 User manual

  • Hello! I am an AI chatbot trained to assist you with the ESAB & 1500 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
F-15-705-A
July, 2002
WHEEL CART
POWERCUT-650, 875, 1125, & 1500
The Wheel Cart is an accessory that permits ease
of mobility in the work place for the POWERCUT
Console.
Assemble as follows:
1. Assemble the swivel casters to the four groups
of four 1/4”—20 studs located on the bottom
of the base using 16 supplied lockwashers and
nuts.
3-1/2” Swivel Casters
0558002276 (PC-875, 1125 & 1500)
3” Swivel Casters
950899 (PC-650)
Base
0558002273 (PC-875 & PC-1125)
0558002274 (PC-1500)
0558003403 (PC-650)
2. Stand the Wheel Cart up on the casters and position
the plasma power unit on to the base. Insert the rubber
feet on both ends into the rectangular slots on the ends
of the base.
3. Slide the positioning bracket onto the bottom lip of the
power supply handle piece and under the base until
the slots line up with the press nuts in the base. Secure
with 3 supplied locknuts and screws. Do the same to
the opposite end.
Positioning Bracket
AM1211 - P/N 0558002275
Be sure this information reaches the operator.
You can get extra copies through your supplier.
POWERCUT-650 ...................................... P/N 0558003399
POWERCUT-875 and POWERCUT-1125 P/N 0558003014
POWERCUT-1500 .................................... P/N 0558003060
1/1