*Control Air Flow*
Slide to remove tray and adjust ange open and closed. For optimal air ow, push anges past 90º.
Additional Support
[email protected] / www.ariavent.com
Flushmount Pro Installation Guide
1 2
Drop in base on suboor and
fasten with wood screws.
*DON’T use provided screws here.
Dry t body into base.
3
Install surface material on top of
base piece so that it is ush
to the body.
4
Place body piece into base. With
the resistance from the ange,
adjust body up and down until it’s
ush with the top of surface.
5 6
Once adjusted to prefered height,
use provided black screws to
fasten body to base piece.
Backll tray with bonding material
and place precut piece of surface
material inside tray.
7
8
Hold in place and ip tray. Apply
even pressure until surface
material lies at with the rim of
tray. Leave to cure.
Insert and slide tray in place.
Enjoy!
*Use provided screws for step #5 only.
/
