EcoSurvivor 34425-TS4 User manual

Brand: EcoSurvivor

Model: 34425-TS4

Type: User manual

This manual is also suitable for

34425

Bluetooth Speaker

with Integrated Battery Pack

Thank you for purchasing your new EcoSurvivor Bluetooth Speaker with

Integrated Battery Pack. Its convenience and practicality make it ideal for travel.

Thanks to its powerful battery, the system delivers full stereo sound, separated

from any main supply, for up to 18 hours. No matter where you are or where you

are going, take this speaker/battery pack on the go.

Package contents:

• Bluetooth Speaker with Integrated Battery Pack

•

2ft Micro USB Charging Cable

• User Manual

• EcoSurvivor Pamphlet

Bluetooth Connection:

Turn the speaker on by pressing the power button for ﬁve seconds. When the

blue LED ﬂashes, the EcoSurvivor Bluetooth Speaker is in pair mode.

Connect to mobile phones/tablet PCs/computers:

1. Activate your phone’s Bluetooth

2. Go to your phone’s Bluetooth settings , scan for new Bluetooth devices

3. Upon device found (EcoSpeaker), click the device name and pair with it

4. After successful pairing, your speaker will sound a prompt tone and the blue

LED light will stay lit.

NOTE: Pairing time is varied with dierent mobile phones. It only needs to pair

the ﬁrst time and it will auto connect the devices which have been already paired

before (speaker will only remember the last 8 paired devices).

Bluetooth Connection:

Short Press to answer calls and to utilize the internal microphone. Short

press to end the call and back to play status. Long press to reject the

incoming call. Long press to dial back the last dialed call, but it will be

invalid if there is no phone conversation.

AUX input mode:

The speaker also features one AUX audio input port. Simply connect the speaker

to your device with the 3.5mm jack audio cable. The green LED will be on

indicating you can play music via wired connection.

Low power indication:

Speaker will indicate if battery is low (battery level 10%). The speaker will need to

be recharged at this point.

Charging and computer connection :

Connect the micro USB charging cable to a computer or USB charger. The red

LED indicator will show the charging status. Red LED will turn o once charging

is complete. (5-6 hours for charging)

Electrical Speciﬁcations:

· Bluetooth compatibility: It conforms to Bluetooth 4.1 Class II and supports

A2DP V1.2, AVRCP V1.4 proﬁles agreement.

· Transmission distance: Up to 10 m

· Sound track: Dual track

· Maximum output: 3W×2

· Signal to noise ratio S / N: ≥ 80dB

· Frequency range: 160Hz-20KHz

· Distortion THD: ≤ 1%

· Speaker unit: Outer diameter 40mm, inner magnet, 4Ω, 5W

Parameters of power:

· Rated voltage: 3.7V DC

· Battery: Built-in lithium battery, 3.7V/4400mA

· Charging Voltage/Current: 5V ± 0.25V / 1A ·Output : 5V . 1A

· Charging time: 6 ± 0.5 hours

34425 v2 10/17/18 NOTE: When using Bluetooth feature and an aux cable is inserted, the

speaker will switch automatically to aux input.

LED status:

1. Bluetooth status: blue LED will ﬂash for pairing mode. Blue LED will

remain on while connected.

2. Aux input mode: green LED will remain on while connected.

3. Charging status: red LED will ﬂash during charging. All four LEDs will

remain on when charging is complete.

Removable Strap:

Removable carry strap can be used to securely

attach or hang the speaker. To open the strap

use a #2 Phillips-Head screwdriver to remove

the Phillips-Head screw.

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: 1) this device may not cause harmful interference, and 2) this device must accept

any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment o and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

This device is measured RF output power is less than the SAR exclusion threshold value for

human head and body. Therefore, SAR test is not necessary.

Function

Answer a call

End or refuse a call

Power ON/OFF

Volume + or -

Next/previous sound

Fuel gauge indicator

Operation

During an incoming call, short press key to

answer the phone, short press again to hang

up phone and continue playing music

Short press key to end the call or long

press to refuse the call

Long press to power on/o

Short press volume +/- to adjust sound level

Long press +/- to skip or return

Press the button next to the aux input jack to

display remaining battery life. The four red

LEDs on front of the speaker will illuminate.

Each LED represents approximately 25% of

battery capacity.

WARNING: RISK OF FIRE AND SHOCK

RISK OF FIRE

• AVOID PLACING THE SPEAKER IN DIRECT SUNLIGHT, NEAR A HEATER OR OTHER

LOCATIONS OF EXTREME TEMPERATURES.

• DO NOT CONTINUE USING OR ATTEMPT TO CHARGE THE SPEAKER IF IT HAS BEEN

PUNCTURED, CRUSHED, DEFORMED, DAMAGED OR IF IT EXHIBITS ANY ABNORMAL

CHARACTERISTICS SUCH AS EXCESSIVE HEATING, SWELLING OR IF IT EMITS AN

ODOR.

• USE ONLY IN DRY LOCATIONS. NEVER IMMERSE THE UNIT IN LIQUIDS.

• DO NOT OPERATE THE SPEAKER NEAR FLAMMABLE MATERIALS, FUMES OR GASES.

• USE ONLY A USB POWER SUPPLY WITH A 5.0V OUTPUT OR COMPUTER USB PORT TO

CHARGE THE SPEAKER.

• DO NOT OPEN THE SPEAKER. THERE ARE NO USER SERVICABLE PARTS.

• TO AVOID AND EXPLOSION OR EXPOSURE TO TOXIC FUMES, DO NOT DISPOSE OF

THE SPEAKER IN A FIRE.

• USE A MILD SOAP AND WATER SHOULD THE BATTERY CONTENTS COME INTO

CONTACT WITH THE SKIN.

• RINSE EYES WITH CLEAN RUNNING WATER SHOULD THE BATTERY CONTENTS COME

INTO CONTACT WITH THE EYES AND SEEK MEDICAL ATTENTION.

• KEEP AWAY FROM CHILDREN. THE SPEAKER IS NOT A TOY.

• DO NOT DROP THE SPEAKER.

MADE IN CHINA

DISTRIBUTED BY JASCO PRODUCTS COMPANY LLC,

10 E. MEMORIAL RD., OKLAHOMA CITY, OK 73114.

This Jasco product comes with a 1-year limited

warranty. Visit www.byjasco.com for warranty details.

Questions? Contact us at 1-800-654-8483

between 7:00AM—8:00PM CST.

Fuel gauge button

input

USB input

USB output

RECYCLABLE

EcoSurvivor 34425-TS4 User manual

Brand: EcoSurvivor

Model: 34425-TS4

Type: User manual

This manual is also suitable for

34425

Download PDF

report

EcoSurvivor 34425-TS4 User manual

This manual is also suitable for

EcoSurvivor 34425-TS4 User manual

Other documents