Pyle PLR14MPF User manual

  • Hello! I am an AI chatbot trained to assist you with the Pyle PLR14MPF User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
PLRI4MPF
User's
Manual
1.Control
Panel
CD
Volume knob with power switch
® SD/MMC
card slot
®
Dial indicator
@
Radio indicator
@
MP3 player indicator
®
U-disk slot
Cf)
Tune knob
@
Tone knob
®
Mode button
® Pause button
@ Forward button
@ Rewind button
@ U-disk and SD/MMC card button @
Band button @ Balance knob
2.0perations
CD
TURN POWER ON/OFF AND ADJUST VOLUME
Rotate " sw.vol" knob clockwise to turn the power
on
and increase volume;
Rotate " sw.vol " knob anticlockwise to decrease volume and turn the power off.
®
RADIO OPERATIONS
Push the
"MODE
" button into for radio state, the
"RA
" indicator lights;
Push the
"BAND
" button into for
"FM
" state, push the
"BAND
" button again
into for
"AM
" state;
Rotate the TUNE knob to receive your desire station, the
dial indicator indicates
the frequency of the station.
@
MP3 PLAYER OPERATIONS
When U-dish
or
SD/MMcard is inserted into the machine, push the " MODE"
button into for MP3 player state, the "
TA
" indicator lights.
@
NEXT/FF
Under U-dick, SD/MMC card playing state, press
">
"
button to increase
program; press and
hold
">
"
button for over 1s to activate program fast
forward function.
® BACKIREW
Under U-disk, SD/MMC card playing state, press
"<"
button to decrease
program; press and
hold "
<"
button for over 1 s to activate program fast
rewind function.
® PAUSE
Under U-disk, SD/MMC card playing state, press"
~I
"
button to stop playing
temporarily; press it again to release pause function.
(j)
U-DISK AND SD/MMC CARD PLAYING SWITCH
When U-disk and SD/MMC card are inserted into the machine, press and
hold
"
~
"
button to switch between U-disk and SD/MMC card.
3.Cautions
Please replace the fuse
of
same specification, do not use other material as fuse.
4.Technical
Parameters
AM Section
F req uency Range--------------------------------------------------------------530
-1
700KHz
Sensitivity-----------------------------------------------------------------------------
~
43d B
S
N
R ------------------------------------------------------------------------------------
;;:,:
40d
B
FM
Section
Frequency Range------------------- -------------------------------------------87-1 08M Hz
Sensitivity------------------------------------------------------------------------------
~
26d
B
S N
R -------------------------------------------------------------------------------------
;;:,:
50d B
General Section
Power Voltage-----------------------------------------------------------------------1
2V
DC
Speaker I m pedance--------------------------------------------------------------------4-8 Q
Power Output-----------------------------------------------------------80WX2 (160W Max)
Dimension-------------------------------------------164mm(W) X43mm(H) X 124mm(D)
5.lnstallation
o
Outside knob
o inside knob
o
nut
o
washer
o
panel
®
washer
o nut
®
fixing strip
®
washer
@ spring washer
@ nut
Dash board
6.Wiring Diagram
Antenna Socket
Main Unit
Right RCA Red
Left
Sp
eaker
+
Blue
_
Blue
w i
th
bl
ack
strip
7.
Troubleshooting
Fault
Reason
Power
indicator
1.
Power
supply
is
not
correc
tl
y
connected
.
doesn
't
light
on
2.
Fuse
is
broken
or
power
wire
is
open
circuit.
1.
No
power
supply
.
2.
Speaker
wire
is
open
circuit.
3.
SD/MMC
card
and
U-disk
haven
't
No sound
music
of
corresponding
format.
4.
SD/MMC
card
and
U-disk
have
bad
contact
.
Low sound (not
1.
R
esistance
of
the
battery
is
high.
clear)
2.
Antenna
is
bad
contact
.
1.
One
channel
of
speaker
wire
is
Mono track
open
ci
rcu
it
.
2.
Amplifier
is
fault
.
To
Battery
+
To Ignition
Switch
Bl
ac
k
L-":"':""'
__
To
Battery-
Green
+
Green
with
_
black
strip
Solution
Right
Spe
a
ker
Connect
power
supply
correctly.
Check
and
connect
fuse
or
power
wire
.
Connect
power
wi
re
.
Connect
speaker
wire.
Check
the
content
in
the
SD/MMC
card
and
U-disk.
Clean
with
alcohol.
Replace
battery
.
Tighten
the
antenna
plug.
Connect
speaker
wire
.
Replace
the
integrate
circu
it
of
amplifie
r.
CAR AUDIO SYSTEMS
BRAND CAR STEREOS
/