ACT Smart Controller Installation guide

ACT
Brand
ACT
Model
Smart Controller
Type
Installation guide
FACTORY DEFAULT
This unit should be reset to its
factory default condition before
installation. To do this, power
the unit up with ALL switches in
the OFF position. The two LED's
will illuminate for about 2 sec.
The correct switch settings may
then be set.
To connect to PC set
DIP 8 to the ON position
Note:
Tamper and Mains Present
are not used.
OP1
TAMPER
MAINS
PRESENT
+
12V DC
-
N/C C
OP2
N/ON/C C N/O
SENSE
CLOCK
DATA
+5V
0V
RED
GREEN
5A 250VAC
5A 30VDC
5A 250VAC
5A 30VDC
1 2 3 4 5 6 7 8
N ADDRESS
8
On
On
Power
Supply Unit
+12V
Network cable is single
shielded twisted pair,
Belden 9501 or similar
ACTSmart Controller Installation
OP3 OP4 0V IP1 IP2 IP3
DTR RX TX 0V B A
SERIAL NETWORK
A
B
0V
SLAVE
ACTSmart2 Unit
OMRON
5A
5A
+
RON
1A 125V
12V DC
0V
N/O
COMM
N/C
B
A
Aux I/O 2
Tamper
Aux I/O 1
RELAY
12V
=
D
C
5A/250V ~AC
Programmable Input
See ACTSmart2 Installation
Manual for connection details.
Total cable length
maximum 1.4km
ACTWinSmart Software
3metres Direct Connect Cable (Supplied)
Shield
Shield
Continue daisy chain to
remaining ACTSmart2
units (maximum 8).
0V
LED Functionality:
Red LED indicates the status of communications with the PC.
Green LED indicates the status of communications with the ACTSmart Units.
Normally they flash rapidly.
If there is a problem they will flash slowly (about once a second).
ACTSmart Controller
18-00036
www.accesscontrol.ie
  • Page 1 1

ACT Smart Controller Installation guide

ACT
Brand
ACT
Model
Smart Controller
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents