1.Thread two headledd screws through the cross bar, then
secure them with four lock nuts. (two on each side of the
mounting plate) Adjust the length of the headless screws
if necessary.
2. Attach the cross bar to the outlet box using two mounting
screws.
3. Pull out the source wires from the outlet box. Make
wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from
the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power
source.
---Attach the fixture grounding wire (usually green
insulation or bare wire) to the cross bar with
the green grounding screw. Then connect it to the
house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the cross bar by inserting the two
headless screws, then secure it with the ball nuts.
5. Install bulbs (not included), see relamping label at socket
area or packaging for maximum allowed wattage.
6. Screw the threaded pipe into the coupling, then secure it with
a washer and hex nut.
7. Attach the frame to the ceiling pan by inserting the threaded pipe, then secure it with the decorative cup and finial.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0115
Outlet Box
House Grounding Wire
Fixture Grounding Wire
Wire Nut(E)
Headless Screw(D)
Ceiling Pan
Socket
Coupling
Hex Nut
Threaded Pipe
Frame
Decorative Cup(G)
Finial(F)
Cross Bar(A)
Green Grounding Screw(C)
Mounting Screw(B)
Lock Nut(G)
Bulb Type A Max.60W
(not included)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (E)
Ball Nut (F)
Cross Bar(A)
Washer
Ball Nut(F)
150112
Hardware Package (included):
or
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
Installation Steps
Headless Screw (D)
Lock Nut
(G)
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.
150112
A: 14"
B: 7"
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Assembly Kit
5206MM (1 SET)
Side Glass Panel
9670AF(4PCS)
Bottom Glass Panel
9671AF(1PC)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Nut (E)
Ball Nut (F)
Cross Bar (A)
Headless Screw (D)
Lock Nut
(G)
A
B
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Cascadia T0109 Installation guide
-
-
-
Cascadia OF14611ST Installation guide
-
-
-
-
-
-
Other documents
-
LNC CA2421-2W User manual
-
C Cattleya CA2241-2W Operating instructions
-
-
Laura Ashley WBLS0133 Installation guide
-
-
Lowes W0192 Assembly And Installation Instructions
-
Design House 578500 Installation guide
-
Craftmade 25621-FR Installation guide
-
Patriot Lighting 130910 Assembly And Installation Instructions
-
