Cascadia T0453 Installation guide

Brand: Cascadia

Model: T0453

Type: Installation guide

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

181121

Cross Bar (A)

Green Grounding

Screw (E)

Mounting Screw (B)

Wire Connector (C)

Lock Nut (F)

Ball Nut (G)

1. Attach two headles screws (D) to the cross bar (A),and

then secure it with four lock nuts (F). Adjust the length

of headless screws if necessary.

2. Attach the cross bar (A) to the outlet box using two

mounting screws (B).

3. Pull out the source wires from the outlet box.

Make wire connections using wire connectors (C) as follows:

---Connect the hot wire (usually black insulation) from the

fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation

or bare wire) to the cross bar (A) with the green grounding

screw (E), and then connect it to the house grounding wire

with a wire connector (C).

Carefully put the wires back into the outlet box.

4. Attach the fixture canopy to the cross bar (A) by inserting the

headless screws (D), and then secure it with two rubber pads

(H) and two ball nuts (G).

5. Install a bulb (not included). Check relamping label at socket

area or packaging for maximum allowed wattage.

6. Attach the glass onto the glass holder, secure it with four

replacement ball nuts.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0453

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn on the power at fuse or circuit box

Rubber Pad (H)

Headless Screw (D)

House Grounding Wire

Outlet Box

Cross Bar (A)

Mounting Screw (B)

Lock Nut (F)

Wire Connector (C)

Headless Screw (D)

Green Grounding Screw (E)

Turn off the power at fuse or circuit box

Installation Steps

Fixture Canopy

Ball Nut (G)

Rubber Pad (H)

Glass Holder

Replacement Ball Nut

Glass

Bulb Type A

Max. 60W

(not included)

181121

Assembly Kit

6003MM (1SET)

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Cross Bar (A)

Green Grounding

Screw (E)

Headless Screw(D)

Mounting Screw (B)

Wire Connector (C)

Lock Nut (F)

Ball Nut (G)

Rubber Pad (H)

Glass 10037CS

A: 11-3/4"

B: 9-3/4”

Cascadia T0453 Installation guide

Cascadia T0453 Installation guide

Cascadia T0453 Installation guide

Related papers

Other documents