Perle IOLAN SDG1 W Quick start guide

Brand: Perle

Model: IOLAN SDG1 W

Type: Quick start guide

Perle IOLAN SDG1 W is a wireless industrial-grade serial device server designed for demanding applications in harsh environments. It enables the connection of serial devices to an Ethernet network or the Internet via Wi-Fi or wired connection for remote access, monitoring, and control. The IOLAN SDG1 W supports various security features, including WPA, WPA2, and 802.1X authentication, ensuring secure data transmission.

IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)

IOLAN SDG1 W

Quick Start Guide

______________________________________________________________

Thisguidecoversbasicinstallationandconfigurationandisintendedforfirsttime

setuporproductevaluation.

Completedetailscanbefoundinthefollowingguidesat

www.perle.com/downloads.

 IOLANUser’sGuide

 IOLANCommandLineInterfaceReferenceGuide

 IOLANSDG1WHardwareInstallationGuide

What’s in the box?

 TheIOLANSDG1W

 QuickStartGuide(thisdocument)

 1XRPSMAantennae

 Poweradapter,strainreliefstrapandrubberfeet

 Wallmountbrackets

Hardware Overview

Button/SwitchFunctions

ResetButton

ToreboottheIOLANSDG1Winsertapaperclipintotheinsetholelabelledas

Resetandgentlypressinwardsandrelease.ThePower/ReadyLEDsontheIOLAN

SDG1WwillgoOnandthenmomentarilyOffwhenreleasedtoshowthattheunit

IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)

2

hasbeenrebooted.Ifyouholdtheresetbuttonbetween3and10seconds,the

IOLANSDG1Wwillresettheconfigurationtofactorydefault(eitherthePerleor

customdefaultconfiguration).Ifyouholdtheresetbuttongreaterthan10

seconds,thentheIOLANSDG1WwillresettheconfigurationtothePerlefactory

defaultconfiguration.

WPSButton

InsertapaperclipintotheinsetholelabelledasWPSandgentlypressinwards.

Pressingthisbuttonforlessthan3secondswillputtheIOLANSDG1WinWPS

mode,greaterthan4secondswillputtheunitinSoft‐APmode.

ConsoleSwitch

ThedipswitchontheIOLANSDG1Wissetinthefactorytoserial(downposition).

UnlessyouplantoattachaconsoletotheIOLANSDG1W,leavethedipswitchin

theserialposition

SerialPort

Pleaserefertothepin‐outtableintheIOLANSDG1WHardwareInstallation

Guideforyourdeviceandensureyouhavetheappropriatecableforconnecting

yourserialdevicetotheserialportontheIOLANSDG1W.

Connecting the Hardware

Power

EitherthebarrelorTB(TerminalBlock)canbeusedtopowertheIOLANSDG1W.



Connectingthebarrelconnector

Plug the power adapter into a power socket and connect the barrel connector end

into the IOLAN SDG1 W. The Power/Ready LED should show a solid green.

Connectingtheterminalblockconnector

1. EnsurepowerisNOTappliedtothewirespriortoconnection.

2. Oneachendwire(12‐20AWG),removetheinsulationfromthecopperwire5

mm(3/16ofaninch).

3. Loosentheleftscrewonthetopoftheterminalconnectorblock,theninsert

yourpositive(+)wireintotheleftterminalandscrewitdowntight(.51Nm

torque).Loosentherightscrewonthetopoftheterminalconnectorblock,

theninsertyournegative(‐)wireintotherightterminalandscrewitdown

tight(.51Nmtorque).

4. Re‐inserttheterminalblockconnectorifremoved.

5. Connectthepowercordstrainrelief,ifdesired.SeeIOLANSDG1WHardware

Guidefordetails.

6. Connectthegroundinglug(notprovided)tothegroundingscrew,ifdesired.

SeeIOLANSDG1WHardwareInstallationGuidefordetails.

IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)

3

ConnectingtheAntennas,Ethernetcableandserialdevice

1. ConnecttheWi‐Fiantennabysimplyscrewingtheantennaontothe

connectorsontheIOLAN.

2. ConnecttheEthernetcable(Cat5/5e)fromtheRJ‐45plug(10/100/1000)to

theHUBorswitchthatwillprovidenetworkconnectivity(ifapplicabletoyour

application).

3. Connecttheserialdevicetotheserialport.SeetheSDG1WHardware

InstallationGuideforpinoutdetails.

Turnonpoweratsource.



Power-on Cycle

WhenthepowerisconnectedtotheIOLANSDG1W,thePower/ReadyLEDwill

cyclethroughseveralsequencesandwillendinasolidgreenoncetheunitisfully

bootedandreadytobeconfigured.IftheLEDisnotsolidgreenaftertwominutes,

seeIOLANSDG1WHardwareInstallationGuide.



LED Guide

SystemReady

 Greensolid—SystemReady

 Greenflashing—SystemisbootingorDIPswitchisinconsolemode

 Yellowflashing—Booting

 Red—Errorcondition.SeeIOLANSDG1WHardwareInstallationGuide

Link10/100/1000(onEthernetLinkConnector)

 Green—1000Mbps(flasheswithactivity)

 Green/Yellow—100Mbps(flasheswithactivity)

 Yellow—10Mbps(flasheswithactivity)

 Off—noLANconnection

WPS(Wi‐FiProtectedSetup)

 Yellowpulsing—ThefirstLEDwithinthesignalstrengthLEDdisplaywillpulse

yellowonandoff

Soft‐APMode(AccessPointMode)

 Greenpulsing—ThethirdLEDwithinthesignalstrengthdisplaywillpulse

greenonandoff

WLAN

 Greensolid—Awirelessconnectionhasbeenestablished

 Greenpulsing—Dataisbeingtransmittedoverthewirelessnetwork

 Off—Nowirelessconnectionisestablished

Signal

 WirelesssignalstrengthfromyellowLEDstogreenLEDswithgreenbeingthe

strongestsignalstrength.

IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)

4

Tx/Rx

 Flashing–Indicatestransmit/receiveserialactivity



Connecting to the IOLAN via the Wi-Fi Network

ThefollowingstepsallowforconnectiontotheIOLANforinitialconfiguration.

InitialSetup–UsingSoft‐APMethod

 TheIOLANSDG1Wmustbepoweredup.

 PresstheinsetWPSbutton(usingapaperclip)for4secondstoenableSoft‐

APmode.TheSignalstrengthLEDdisplayshouldshowapulsinggreenLEDon

thethirdlightfromthelefttorighttoconfirmyouareinSoft‐APmode.

 TheIOLANSDG1WislistedonyournetworkconnectionsonyourPCor

wirelessclient.ItwillappearasSSID:IOLAN‐xxxxxx(thelast6digitsofthe

IOLANwirelessMACaddress‐foundontheproductlabel).

 SelectthisSSIDonthePC.

 Whenapasswordisrequested,enterthepasswordprintedontheproduct

label.

 YoushouldnowbeconnectedtotheIOLAN’sWirelessinterface.

 UseaWebbrowsertoconnecttothedefaultaddressoftheIOLANSDG1W

at(192.168.0.1).

 Thedefaultuseridis“admin”andthedefaultpasswordis“superuser”(case

sensitive).

 YoucannowconfigureandmanageyourIOLANSDG1WusingtheIOLAN

WebManagerapplication.

Note:Youshouldchangetheadminpasswordtorestrictunauthorizedaccessto

yourIOLAN.

ForadditionalmethodsofconfiguringyourIOLAN(i.e.,DeviceManager,Telnet,

SNMP),pleaserefertotheIOLANUser’sGuide.



Registering the IOLAN

YoushouldregisterIOLANonlineat:

www.perle.com/support_services/warranty_reg.asp

Contacting Technical Support

ContactinformationforthePerleTechnicalAssistanceCenter(PTAC)canbefound

atthelinkbelow.

www.perle.com/support_services/support_request.shtm



Perle IOLAN SDG1 W Quick start guide

Brand: Perle

Model: IOLAN SDG1 W

Type: Quick start guide

Download PDF

report

in other languages

polski: Perle IOLAN SDG1 W Skrócona instrukcja obsługi

Perle IOLAN SDG1 W Quick start guide

Perle IOLAN SDG1 W Quick start guide

in other languages

Related papers

Other documents