2. Perle
  3. IOLAN SDG1 W
IOLAN SDG1 W

Perle IOLAN SDG1 W Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Perle IOLAN SDG1 W Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)
IOLAN SDG1 W
Quick Start Guide
______________________________________________________________
Thisguidecoversbasicinstallationandconfigurationandisintendedforfirsttime
setuporproductevaluation.
Completedetailscanbefoundinthefollowingguidesat
www.perle.com/downloads.
IOLANUser’sGuide
IOLANCommandLineInterfaceReferenceGuide
IOLANSDG1WHardwareInstallationGuide
What’s in the box?
TheIOLANSDG1W
QuickStartGuide(thisdocument)
1XRPSMAantennae
Poweradapter,strainreliefstrapandrubberfeet
Wallmountbrackets
Hardware Overview
Button/SwitchFunctions
ResetButton
ToreboottheIOLANSDG1Winsertapaperclipintotheinsetholelabelledas
Resetandgentlypressinwardsandrelease.ThePower/ReadyLEDsontheIOLAN
SDG1WwillgoOnandthenmomentarilyOffwhenreleasedtoshowthattheunit
IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)
2
hasbeenrebooted.Ifyouholdtheresetbuttonbetween3and10seconds,the
IOLANSDG1Wwillresettheconfigurationtofactorydefault(eitherthePerleor
customdefaultconfiguration).Ifyouholdtheresetbuttongreaterthan10
seconds,thentheIOLANSDG1WwillresettheconfigurationtothePerlefactory
defaultconfiguration.
WPSButton
InsertapaperclipintotheinsetholelabelledasWPSandgentlypressinwards.
Pressingthisbuttonforlessthan3secondswillputtheIOLANSDG1WinWPS
mode,greaterthan4secondswillputtheunitinSoft‐APmode.
ConsoleSwitch
ThedipswitchontheIOLANSDG1Wissetinthefactorytoserial(downposition).
UnlessyouplantoattachaconsoletotheIOLANSDG1W,leavethedipswitchin
theserialposition
SerialPort
Pleaserefertothepin‐outtableintheIOLANSDG1WHardwareInstallation
Guideforyourdeviceandensureyouhavetheappropriatecableforconnecting
yourserialdevicetotheserialportontheIOLANSDG1W.
Connecting the Hardware
Power
EitherthebarrelorTB(TerminalBlock)canbeusedtopowertheIOLANSDG1W.
Connectingthebarrelconnector
Plug the power adapter into a power socket and connect the barrel connector end
into the IOLAN SDG1 W. The Power/Ready LED should show a solid green.
Connectingtheterminalblockconnector
1. EnsurepowerisNOTappliedtothewirespriortoconnection.
2. Oneachendwire(12‐20AWG),removetheinsulationfromthecopperwire5
mm(3/16ofaninch).
3. Loosentheleftscrewonthetopoftheterminalconnectorblock,theninsert
yourpositive(+)wireintotheleftterminalandscrewitdowntight(.51Nm
torque).Loosentherightscrewonthetopoftheterminalconnectorblock,
theninsertyournegative(‐)wireintotherightterminalandscrewitdown
tight(.51Nmtorque).
4. Re‐inserttheterminalblockconnectorifremoved.
5. Connectthepowercordstrainrelief,ifdesired.SeeIOLANSDG1WHardware
Guidefordetails.
6. Connectthegroundinglug(notprovided)tothegroundingscrew,ifdesired.
SeeIOLANSDG1WHardwareInstallationGuidefordetails.
IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)
3
ConnectingtheAntennas,Ethernetcableandserialdevice
1. ConnecttheWi‐Fiantennabysimplyscrewingtheantennaontothe
connectorsontheIOLAN.
2. ConnecttheEthernetcable(Cat5/5e)fromtheRJ‐45plug(10/100/1000)to
theHUBorswitchthatwillprovidenetworkconnectivity(ifapplicabletoyour
application).
3. Connecttheserialdevicetotheserialport.SeetheSDG1WHardware
InstallationGuideforpinoutdetails.
Turnonpoweratsource.
Power-on Cycle
WhenthepowerisconnectedtotheIOLANSDG1W,thePower/ReadyLEDwill
cyclethroughseveralsequencesandwillendinasolidgreenoncetheunitisfully
bootedandreadytobeconfigured.IftheLEDisnotsolidgreenaftertwominutes,
seeIOLANSDG1WHardwareInstallationGuide.
LED Guide
SystemReady
Greensolid—SystemReady
Greenflashing—SystemisbootingorDIPswitchisinconsolemode
Yellowflashing—Booting
Red—Errorcondition.SeeIOLANSDG1WHardwareInstallationGuide
Link10/100/1000(onEthernetLinkConnector)
Green—1000Mbps(flasheswithactivity)
Green/Yellow—100Mbps(flasheswithactivity)
Yellow—10Mbps(flasheswithactivity)
Off—noLANconnection
WPS(Wi‐FiProtectedSetup)
Yellowpulsing—ThefirstLEDwithinthesignalstrengthLEDdisplaywillpulse
yellowonandoff
Soft‐APMode(AccessPointMode)
Greenpulsing—ThethirdLEDwithinthesignalstrengthdisplaywillpulse
greenonandoff
WLAN
Greensolid—Awirelessconnectionhasbeenestablished
Greenpulsing—Dataisbeingtransmittedoverthewirelessnetwork
Off—Nowirelessconnectionisestablished
Signal
WirelesssignalstrengthfromyellowLEDstogreenLEDswithgreenbeingthe
strongestsignalstrength.
IOLANSDG1WQuickStartGuide‐P/N5500346‐10(RevC)
4
Tx/Rx
Flashing–Indicatestransmit/receiveserialactivity
Connecting to the IOLAN via the Wi-Fi Network
ThefollowingstepsallowforconnectiontotheIOLANforinitialconfiguration.
InitialSetup–UsingSoft‐APMethod
TheIOLANSDG1Wmustbepoweredup.
PresstheinsetWPSbutton(usingapaperclip)for4secondstoenableSoft‐
APmode.TheSignalstrengthLEDdisplayshouldshowapulsinggreenLEDon
thethirdlightfromthelefttorighttoconfirmyouareinSoft‐APmode.
TheIOLANSDG1WislistedonyournetworkconnectionsonyourPCor
wirelessclient.ItwillappearasSSID:IOLAN‐xxxxxx(thelast6digitsofthe
IOLANwirelessMACaddress‐foundontheproductlabel).
SelectthisSSIDonthePC.
Whenapasswordisrequested,enterthepasswordprintedontheproduct
label.
YoushouldnowbeconnectedtotheIOLAN’sWirelessinterface.
UseaWebbrowsertoconnecttothedefaultaddressoftheIOLANSDG1W
at(192.168.0.1).
Thedefaultuseridis“admin”andthedefaultpasswordis“superuser”(case
sensitive).
YoucannowconfigureandmanageyourIOLANSDG1WusingtheIOLAN
WebManagerapplication.
Note:Youshouldchangetheadminpasswordtorestrictunauthorizedaccessto
yourIOLAN.
ForadditionalmethodsofconfiguringyourIOLAN(i.e.,DeviceManager,Telnet,
SNMP),pleaserefertotheIOLANUser’sGuide.
Registering the IOLAN
YoushouldregisterIOLANonlineat:
www.perle.com/support_services/warranty_reg.asp
Contacting Technical Support
ContactinformationforthePerleTechnicalAssistanceCenter(PTAC)canbefound
atthelinkbelow.
www.perle.com/support_services/support_request.shtm
/