FLEXISTORE 1533
BASE INSTRUCTIONS
Flat and firm base. Recommended: concrete, tarmac or paving flags.
Min. distance from walls/ shrubbery: 1000mm.
Min. base size (WxDxH) 1730mm x 3770mm x 50mm.
LEVELING THE UNIT
Correctly level the constructed unit using the shims (ZCOMPPLAS)
provided prior to fixing the unit to the ground. Slide the packing pieces
under the corners of the unit base as required until an equal gap has
been achieved around the door allowing for its smooth operation and
alignment.
For maintenance instructions of this product visit www.asgardsss.co.uk
Warning: some panels may weigh over
20Kg. Beware of manual handling
6mm
Dia.
13mm
Spanner
18V
x2
SEALANT
Posi-Driv
Screwdriver
It is always recommended to anchor the unit to the ground. Drill through
the four holes in the base of the unit using 6mm dia masonry drill to a
depth of 70mm. Screw in the anchor fixings. (These have a self cutting
thread). If not anchoring the unit, fit the self seal plugs BEFORE
BUILDING to seal the fixing holes from underneath.
TOOLS REQUIRED
Power driver POSI-DRIV screwdriver, 6mm dia. masonry drill, a 13mm
socket or spanner.
ZSCREW32 x12
ZSILCOL1 x1
ZSCREW61 x295
ZSCREW340 x9
ZCOMPPLZS02 x12
ZCOMPPLAS22-23-24 x6
2x 2mm, 2x 3mm, 2x 5mm
LH REAR SIDE PANEL 44160 x1
RH REAR SIDE PANEL 44161 x1
RH EXT. SIDE PANEL 44292 x1
LH EXT. SIDE PANEL 44291 x1
RH BACK PANEL 44159 x1
REAR TOP PANEL
44156 x1
EXTENSION TOP PANEL
44293 x1
FRONT TOP PANEL
44157 x1
LH BACK PANEL 44158 x1
REAR BASE
PANEL 44166 x1
FRONT BASE
PANEL 44378 x1
EXT. BASE
PANEL 44290 x1
FASCIA PANEL 44167 x1
RH FRONT SIDE PNALE 44163 x1
RH FRONT PANEL 44376 x1
DOOR ASSEMBLY 44374 x1
LH FRONT PANEL 44164 x1
LH FRONT SIDE PANEL 44162 x1
Warning: Please keep
this key card safe! Refer
to if replacement key is
required.
00001
YOUR UNIQUE
KEY CODE