Fishbone Offroad FB31127 Installation guide

Brand
Fishbone Offroad
Model
FB31127
Category
Car kits
Type
Installation guide

This manual is also suitable for

FB311XX
Jeep® Wrangler
Fishbone Hood Louver
REQUIRED TOOLS
10mm Socket
3mm Allen
Drill
3/16” Drill Bit
KIT CONTAINS
Fishbone Hood Louver
3mm Button Head Bolts
Washers
Nyloc Nut
QTY
1
24 or 26
24 or 26
24 or 26
FB311XX
Jeep® Wrangler
Fishbone Hood Louver
1
1) PREPARE YOUR VEHICLE
Remove any flare or accessories on the hood of
your vehicle, or anything that might get in the way
of the installation, such as windshield bumpers and
footman loops.
2) MARK DRILL POINTS
Place the louver on your hood as desired. With a
marker, mark the location of the bolt holes onto the
hood, while ensuring the louver doesn’t slide
around.
Remove the louver. With a hole punch, punch
pilots into the hood to make drilling easier.
Optional: If the louver you purchased is Raw-
Unfinished aluminum, begin coating it in your
desired color at this time.
3) DRILL
Begin drilling the pilots using a 3/16” drill bit. Be
careful to not drag metal shavings and across the
hood and scratch the paint.
FB311XX
Jeep® Wrangler
Fishbone Hood Louver
2
4) INSTALL HOOD LOUVER
Replace the louver and begin installing it using the
included bolts, washers, and nyloc nuts. We
recommend loosely securing every bolt before
tightening with a 3mm Allen and a 10mm Socket.
5) REPLACE HOOD ACCESSORIES
With the louver secured, replace any accessories
removed.
6) ENJOY YOUR NEW FISHBONE OFFROAD HOOD
LOUVER!
  • Page 1 1
  • Page 2 2
  • Page 3 3

Fishbone Offroad FB31127 Installation guide

Brand
Fishbone Offroad
Model
FB31127
Category
Car kits
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents