DV8 OFFROAD TLJL-01 Installation guide

Hello, I have reviewed the installation instructions for the DV8 Tail Light Guards TLJL-01. This document provides a step-by-step guide on how to install the tail light guards, including details on separating the components, securing and wiring the new lights. I'm ready to answer specific questions about the installation process or product features.
What should I do before removing the tail light?

What should I do after I remove the bolt?

What should I do before securing the light?

DV8 JL Tail Light Guards (Non-proximity sensor)

TLJL-01

1. On each side of the JL, near the tail light, you will see these covers. Pop them off to access the single tail light

bolt. Remove the bolt and the light should come out.

2. Once removed, separate both the backing bracket and the light guard to their appropriate side.

Passenger

Driver

3. Place backing bracket on the back of the light.

4. Slide the light and backing bracket into the tail light guard as shown below. Install screws loosely.

5. Once both lights are built, connect the wiring and place them back into the holes for reinstallation. With the

tail light guard housing loose, you can align them perfectly before placing the factory light bolt into light.

Secure the light guard bolts before securing the light. Replace caps on interior over light bolts.

If you have any questions, please email us at

[email protected] or call us at 951-680-9595