QMS 2560 Accessory Installation Manual

Brand: QMS

Model: 2560

Type: Accessory Installation Manual

11760287-001A

• QMS

2560 Print System •

Duplex Unit Installation

This document replaces the duplex unit installation instructions in the QMS 2560 Print System Options manual (P/N 1800533-001A) and the QMS 2560 Print

System Installation Guide—Options (P/N 1760249-001A). These instructions have been revised to be more complete.

Remove all pieces from the

carton.

Remove all of the

protective shipping foam,

plastic coverings, and tape

from the pieces.

Turn off and unplug the

printer, and then disconnect

all interface cables.

»Caution:

It is very

important to turn off the

printer before continuing

with this installation.

On the right side of the

printer, remove the cover in

the upper-right corner.

Remove the two screws

from the middle cover, but

leave the cover attached.

Remove the two screws

from the lower cover, and

then remove the cover.

Remove the cover of the

socket compartment on the

right corner of the printer.

With three screws, attach

the duplex guide unit to the

printer.

Plug the duplex guide unit

cable into the lower-left

connector inside the socket

compartment.

Set the duplex unit onto the

duplex guide unit.

With your hand against the

duplex unit to hold it into

place, tighten both of the

recessed screws of the

duplex unit so that it is

secured to the printer.

Insert the duplex unit

cables into the remaining

two connectors inside the

socket compartment.

Using the screw you

removed earlier, reattach

the cover of the socket

compartment to the printer.

»Note:

Make sure that the

connector cords are

completely enclosed

inside of the socket

compartment before

tightening the cover

completely.

Remove the small cover

located on top of the

printer.

Pull back the green tension

device in the direction of

the arrow.

»Note:

The tension wire

supports the weight of the

duplex unit when it’s

open. Be sure to return

the wire to its original

position if you remove the

duplex unit from the

printer.

Reconnect the interface

cables.

Plug the printer back in,

and turn it on.

Print a startup page and

make sure that “Duplex” is

identified as an installed

option.

On the Options tab of the

QMS printer driver select

“Duplex Unit Installed.”

3 4

5 6

QMS 2560 Accessory Installation Manual

QMS 2560 Accessory Installation Manual

QMS 2560 Accessory Installation Manual

Related papers

Other documents