IMPORTANT:

• ALLINSTALLATIONWORKSHOULDBEDONEBYACCREDITEDPROFESSIONAL.

• SHUTOFFPOWERSUPPLYATFUSEORCIRCUITBREAKER!

• USEONLYTHESPECIFIEDBULBS.DONOTEXCEEDTHEMAXIMUMWATTAGE!

CONNECTING THE WIRES

3.Attachthexture’swirestothepowersupplywiresfromthe

junctionbox.Connectblacktoblack(orsmooth);whitetowhite(or

ribbed);groundtoground(greenorcopper).Twisttheendsofthe

wirepairstogether,thentwistonawireconnector.Makesureall

contact the place of purchase.

AssemblyInstructions:9808-BA3/LSF (Seaport)

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

PREPARING FOR INSTALLATION

Remove all of the contents from the carton. See the important notes above. Shut off the power at the circuit breaker

and completely remove the old xture from the wall or ceiling, including the old mounting strap.

Please Note: This xture may be mounted on the wall or ceiling.

1.Mountingstrap(A)maybeattachedtobackplate(G).Ifthemountingstrapisattached,removescrews(B)todetach.The

Fixture Wires

4.Placethexture’sbackplate(G)overmountingstrap(A)sothattheholesinmountingstrap(A)lineupwiththeholesinbackplate(G).

Usetheprovidedscrewdrivertothreadscrews(B)intobackplate(G)untilbackplate(G)issnugagainstthewallorceiling.

6.Installlightbulbs(notprovided)basedonthexture’sspecications.Donotexceedthemaximumwattage.

7.Slidemetalcages(H)uptothebottomofcaps(I).Securethemetalcagesinplacewithdecorativenuts(F).

Please note that you can move the light sources at joints (C) to adjust the direction of the light.

Yourinstallationiscomplete.Turnonthepowerandtestthexture.