VXS9118
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the whole instruction guide before getting started with the installation. Professional installation is
recommended for this product.
CONTENTS
100W Alarm/Siren Speaker
Speaker Wires
SAFETY INSTRUCTIONS
Set the speaker up for use only in areas with adequate ventilation.
Avoid sounding the speaker when in close range to your ear(s) or the ear(s) of others.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drill operations.
Inspect the installation location to make sure there are no components, wires or any other part that could be
damaged when drilling the bracket's mounting holes.
MOUNTING
Identify a suitable area for mounting, preferably an unobstructed sheet-metal surface like the frame or body of
the vehicle so as to provide a firm platform which will help protect the horn from damage due to excessive
shaking. Do not attach the speaker to any plastic or other flexible material.
Using the bracket as a guide, mark the positions for the holes, then perforate to size using a drill.
Use the mounting hardware (not provided) to fasten the horn.
Route the wires through the vehicle's firewall or roof depending on speaker’s mounting location. Be careful to
avoid sharp ends which could damage the horn’s wire.
IMPORTANT: The downward orientation of the speaker will prevent the unit from collecting any water.
VXS9118
INSTALLATION GUIDE
PAGE 2 of 2
SPEAKER WIRING
Connect the red wire of the speaker to the positive (+) terminal of your siren's audio output.
The black wire of the speaker is connected to the negative (-) terminal of your siren's audio output.
/
