2. BLOTZ
  3. B10-ACC-406

BLOTZ B10-ACC-406, B10_ACC_406 Assembly Instructions

  • Hello, I'm a chat assistant and I've reviewed the instructions for the BLOTZ Rooftop Lift B10-ACC-406. This document provides guidance on assembling the 10mm model using glue and a modeling knife. It also suggests using pegs or elastic bands to hold pieces during the drying process. I'm ready to answer any questions about building your model.
  • What type of glue is required for assembly?
    Is any special tool required for assembly?
    What can be used to hold parts while the glue dries?
10mm Rooftop Lift
B10-ACC-406
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
The lift is formed from the pieces shown above.
Glue the front and back pieces to the roof using the
lugs, the attach the end walls.
/