2. Computers & electronics
  3. Audio & home theatre
  4. Loudspeakers
  5. Avaya
  6. 70V
70V

Avaya 70V User manual

  • Hello! I am an AI chatbot trained to assist you with the Avaya 70V User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Where can the Universal Bi-Directional 70V Cabinet Speaker be mounted?
    What type of environment is the speaker designed for?
    How should the speaker be mounted?
    Can the speaker be mounted on a pole?
    What is the recommended speaker wire?
    How should the speaker wires be connected?
    Is a single speaker required to be interconnected?
The Universal Cabinet Speaker should be mounted indoors on a suitable flat surface, such as a wall or ceiling.
Note: When required, the speaker may also be mounted on a pole by using metal banding tape, or other suitable
material, to secure the bracket to the pole.
Use the bracket as a template and mark a screw location in the center of each keyhole slot.
Note: Ensure that the mounting position allows for easy wire connection and volume adjustments.
Install screws in the locations marked. Use anchors if necessary to provide a solid mounting (screws and anchors are
provided). Leave enough room so the bracket can be slipped over the screw heads.
Universal Bi-Directional
70V Cabinet Speaker
Description
Issue 1, October 1999
54-2015-01 Printed in USA 9910
© 1999 Bogen Communications Inc. All rights reserved.
Specifications subject to change without notice.
Select Code: 701-000-119
PEC Code: 5330-205
COM Code: 408184042
Model: LUBIDI70VS
Speaker Installation
The Universal Bi-Directional 70V Cabinet Speaker connects to a voice paging system's 70-volt output. This speaker can be
used as a wall, ceiling, or corridor speaker.
ATTENTION: This speaker is designed to be used in an office environment.
1
2
View of Control Area as
seen from the opposite
direction.
Values shown are in watts.
1
/32
1
/64
1
/128
0
1
/16
1
/8
1
/4
1
/2
1
2
1
/256
Speaker Wire Connection
Speaker
Mounting
Bracket
Screw
(-)
(+)
(-)
(+)
Note:
Connections shown are for inter-
connected speakers. A single speaker
does not require outgoing wiring.
Maintain proper speaker phasing. Each conductor in the
speaker wire must be connected to the same terminal on
each speaker, as shown below.When using shielded speaker
wire, and wiring from speaker to speaker, wire the shield
drains to provide a continuous shield to the next speaker.
The shield wire should never be terminated on the speaker.
Note:
Use 22 AWG shielded, twisted pair on all wire
runs. Com Code: 401882956. Pec Code: 2734-SPK.
3
Attenuator Control
(Volume)
Page 1 of 1
Red screw is (+). Silver screw is (-).
/