2. PEDROLLO
  3. COD. Z-DPL90073UK
COD. Z-DPL90073UK

PEDROLLO COD. Z-DPL90073UK User manual

  • Hello! I've reviewed the datasheet for the PEDROLLO EP pump protector. This document details how the device safeguards your pump from various issues like dry running, overcurrent, and voltage fluctuations. I'm ready to answer any questions you might have about its features and operation.
  • What does the EP electronic device protect the pump against?
    What is the single-phase supply voltage for the EP device?
    What is the maximum current for pump motor?
    What does the multicoloured LED light indicate?
Electronic device for protection of the pump
PRODUCT DESCRIPTION
The EP electronic device protects the pump by
automatically stopping it in cases of dry running,
overcurrent, voltage too high / voltage too low.
TECHNICAL DATA
Single-phase supply voltage 110/230 Vac
Acceptable voltage variations ± 10%
Frequency 50-60 Hz
Maximum current for pump motor 10 A
Operating temperature min 5 °C | max 45 °C
Maximum ambient temperature 55 °C
Fig. 1
Fig. 2
Fig. 3
Fig. 4
COD. Z-DPL90073UK
Electronic device for the protection of the pump
• LED
• START/STOP
CONTROL PANEL
•Key with function of START/STOP, self-learning and alarm reset.
•Multicoloured LED light.
Flashes and changes
colour depending on the status of the device EP.
Description LED light Meaning of the LED light
Light o Device switched o
Fixed GREEN
warning light Device switched on
Fixed BLUE
warning light Device operating correctly
Flashing RED
warning light Dry running
Fixed RED warning light Overcurrent
Fixed YELLOW
warning light Voltage/Voltage too low
Continuous change
in warning light colour Self-learning phase (WIZARD)
INSTALLATION AND OPERATION
Once the correct operation of the water system has been veried,
proceed as follows:
•Run the pump with the delivery point open (Fig.1).
•Disconnect the plug of the power cable of the pump from the power
outlet leaving the delivery point open and fully discharge the system
(Fig. 2).
•Insert the plug of the pump power cord into the EP device (Fig.3).
•Insert the EP into the power socket (Fig. 4) and start the self-learning
procedure (see instruction manual).
After checking the self-learning procedure you can use the installation.
/