FEATURES
1. Automatic Dusk to Dawn
operation
2. IP44 Waterproof rating
3. Poly-Carbonate construction
INSTALLATION METHOD
1. Remove contents from packaging
2. Place light head upside down. Twist off the
solar panel section (Anti-clockwise direction)
and locate “ON/OFF” power switch
3. Switch button to “ON” to activate battery &
controller
4. Decide on your installation process, either
Surface mount using supplied screws or
Spike mount. Locate and use the following
accessories
(A) Surface Mount
Attach the two poles by connecting the ends
together (FIGURE 1). Connect the surface
mount base on the bottom of the post &
using supplied fixings, secure to a solid base
(FIGURE 2)
(B) Spike Mount
The spike can be found tucked in
the cardboard packaging.
Remove spike & re-install
surface mount base. Press spike
into the underside and spike
fitting into your chosen location
(FIGURE 3)
5. Remove protective membrane from solar
panel & your light is now ready for use
IMPORTANT NOTES
Please ensure you place your solar panel in a location
where it can achieve a minimum of 6HRS DIRECT
SUNLIGHT
Be aware that on overcast/cloudy days, the solar panel
will still charge. However, not as efficiently as a sunny
day, so the battery may not reach full capacity.
Therefore, your light may turn off earlier than specified.
It’s best not to install these lights underneath a street
light, porch light etc. because this may stop the
automatic day-night sensor triggering and result in your
lights not turning on