Solar Lighting DIRECT SLDBLK-100B Operating instructions

Brand: Solar Lighting DIRECT

Model: SLDBLK-100B

Type: Operating instructions

Solar Lighting DIRECT SLDBLK-100B is a versatile lighting solution designed for outdoor use, featuring automatic day-night operation, multiple color options, and easy installation. With its built-in photoelectric cell, it automatically turns on at dusk and off at dawn, providing up to 8-10 hours of illumination every night. Choose between "Flash" or "Constant On" modes to suit your preference, and select from a variety of colors, including blue, green, red, white, warm white, or RGB (red, green, and blue).

INSTRUCTION GUIDE

Residential Bud Light Kits

PACKAGE CONTENTS

1. 1 x String lights

2. 1 x Remote Solar Panel

3. 1 x Ground Mount Spike

FEATURES

1. “Plug and Play” Installation

2. Built in Photo Electric Cell

3. 8-10 hours Operation every day

4. Mode Selection Switch for “Flash” or

“Constant On” options

5. DIY and Easy to Install

6. Cable Colour - SLDBLK-100B/R/G - Green

7. Cable Colour - SLDBLK-100RGB/W/WW

- Transparent

8. Spike or Surface Mounting Option for

Remote Solar Panel

9. Colours Available – Blue OR Green OR Red

OR White OR Warm White OR RGB (Red,

Green & Blue)

INSTALLATION METHOD

1. Remove contents from packaging

2. Decide where to situate your lights and

mount or spike the solar panel accordingly

(Where the light will receive maximum direct

sunlight – See “Important Notes”)

3. Turn your lights “ON” by depressing the

“ON/OFF” button on the solar panel

(Please note: All kits are sent out in the

“OFF” position)

4. Temporarily cover solar panel with non-

transparent surface for testing purposes only

(this is so the Day/Night Sensor in the fitting

registers as night-time) – If you have turned

the light on correctly, the light should

illuminate

5. Whilst light is on, select desired working

mode by pressing the “MODE” button on the

solar panel

6. Remove the non-transparent surface. Your

light is now ready to use

Customer Service Number: 1300 135 911 www.solarlightingdirect.com.au

Model No. SLDBLK-100B, SLDBLK-100R, SLDBLK-100G, SLDBLK-100RGB,

SLDBLK-100W, SLDBLK-100WW

IMPORTANT NOTES

 Please ensure you place your solar panel in a location

where it can achieve a minimum of 6HRS DIRECT

SUNLIGHT

 Be aware that on overcast/cloudy days, the solar panel

will still charge. However, not as efficiently as a sunny

day, so the battery may not reach full capacity. Therefore,

your light may turn off earlier than specified

 It’s best not to install these lights underneath a street

light, porch light etc. because this may stop the automatic

day-night sensor triggering and result in your lights not

turning on

Phenomenon

Cause

Inspection Method

Solution

Light won’t

turn on

Switch

hasn’t

been

turned

Determine what

position the switch is

Turn the switch

Battery

has run

flat

Period of rainy or

cloudy weather or

installation site

doesn’t provide

enough direct sunlight

Charge the light

in direct

sunlight for 1-2

days then check

again

The light only

stays on for a

short amount

of time

Low

Battery

1. Bad installation site

for the solar panel

2. Dust or leaves are

covering the panel

3. Long period of

overcast weather

1. Charge the

battery in direct

sunlight for 1-2

days with the

switch off, then

check again

2. Clean the

solar panel

Battery

Failure

1. Access the light and

& replace battery

2. Battery has

matured

Contact SLD

Customer

Service to buy

new batteries

TROUBLE SHOOTING

Solar Lighting DIRECT SLDBLK-100B Operating instructions

Solar Lighting DIRECT SLDBLK-100B Operating instructions

Solar Lighting DIRECT SLDBLK-100B Operating instructions

Related papers

Other documents