2. WHITECROFT LIGHTING
  3. CNSLD20

WHITECROFT LIGHTING CNSLD20 User manual

  • Hello! I've reviewed the product specification for Whitecroft's Starline Multiflex LED strips, specifically the CNSLD20 and CNSLD100/250 models. This document covers important details like installation, soldering, surface preparation, and maintenance guidelines. I'm ready to answer any questions you have about these products or the provided document.
  • What is the maximum soldering time that should not be exceeded?
    What should be avoided during cleaning of reflectors and lenses?
    What type of tests should not be performed?
GENERAL INFORMATION
1) A qualified electrician, in accordance with IEE wiring regulations should carry out connection
to mains wiring.
2) Electrical Class I or II luminaire - see wiring diagrams below
3) Ensure that the rated voltage and frequency requirements are compatible with the available
mains supply.
4) Cleaning of reflectors and lenses should be carried out using clean, soft and lint free cloths
and anti-static cleaning fluid
5) Do not carry out high voltage insulation test, i.e. 500/1000v this may damage internal
components.
TECHNICAL SUPPORT
Telephone: 0161 331 5700
E-mail: technical@whitecroftlight.com
http://www.whitecroftlighting.com/
Whitecroft Lighting Limited
Burlington Street, Ashton-under-Lyne, Lancashire OL7 0AX
Telephone
0161 330 6811
Facsimile:
0161 331 5855
Registered No. 3848973 England Registered Office: As above
OCT 2021 - RevC
Starline Multiflex
Page - 4 Page - 1
CNSLD100/250
CNSLD20
Page - 2 Page - 3
Product specification
Ambient Temperature -40 to +50°C
Voltage 24V DC
Ingress Protection IP00
Information to consider before install:
Map layout abnd orientation before making any cuts.
Check polarity will be correct on loyout.
Allow 20-30mm extra trunking if being used so end caps can be fitted correctly.
Avoid mechanical stress on the tape, for example any sharp bends that may cause kinks in
the tape.
Make sure surface is clean and smooth to get a strong bond.
Cut length 70mm
Soldering
Lead wires can be soldered on to the tape using the designated soldering pads, polarity
MUST be checked before soldering. The maximum soldering time is 3 seconds and the solder
temperature must not exceed 662°F (350°C). Once soldered the connection can be shrink
wrapped using a heat gun(both not provided).
Quick Connect
The tape can connected using a Quick connector(not included see website). To apply peel
back the back off the tape roughly 15-20mm and place it in open connector making sure the
polarity is correct and the contact pads are engaged, once correct close the connector.
Surface preperation
If the tape is being applied directly to a surface make sure it is clean and smooth to get a
goobond witht the tape. If not use a alcohol solution to wipe down the surface and leave to
dry. If the surface is not smooth then paint or primer can be added to help the bond.
•
•
•
•
•
•
/