Vixen Horns VXH6810C Owner's manual

Vixen Horns
Brand
Vixen Horns
Model
VXH6810C
Type
Owner's manual

This manual is also suitable for

VXH6808C
INSTALLATION GUIDE
PAGE 1 of 2
BEFORE BEGINNING YOUR INSTALLATION
Read through the whole instruction guide before getting started with the installation. Professional installation is
recommended for this product.
CONTENTS
8-Tune Musical Air Horn (Chrome Plated)
8-switch Wired Control Box with Wire Harness
1/4” OD Air Line
Mounting Hardware
SAFETY INSTRUCTIONS
Avoid dismantling this horn’s electrical elements.
Avoid touching compressor components with your bare hands immediately after or during use.
Avoid setting up any parts of the horn where there is a risk of falling off or risk of coming in contact with water.
Avoid reaching out to touch or pick up any fallen or water submerged parts.
Set the horn up for use only in areas with adequate ventilation.
Avoid sounding the air horn when in close range to your ear(s) or the ear(s) of others.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drill operations.
Ensure that your air system has no pressure before starting the installation.
The specific voltage requirement for this horn is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.
MOUNTING
HORN
Identify a suitable area for mounting, preferably an unobstructed sheet-metal surface like the frame or body of
the vehicle so as to provide a firm platform which will help protect the horn from damage due to excessive
shaking. Do not attach the horn to any plastic or other flexible material.
Using the bracket as a guide estimate and mark the positions for the holes and then perforate to size using a
drill.
Use the provided mounting hardware to fasten the horn.
CONTROL BOX
Find a mounting location for the control box in which you will have access to the buttons and connector.
IMPORTANT: Make sure that the control wire harness can reach the connector in the horn.
Mount the unit on the location chosen using the small screws, washers and nuts provided.
VXH6808C
INSTALLATION GUIDE
PAGE 2 of 2
AIR LINE INSTALLATION
Using the provided 1/4" OD air line,
cut the size needed.
Push hose into the push to connect
cross fitting located in the top of the
horn.
Connect the other end of the air line
to the fitting on your air supply.
If you need to disconnect the air line
from the solenoid pull away the air
line while pushing the plastic part of
the pneumatic fitting.
ELECTRICAL CONNECTIONS
Locate the two wires in the air valves distribution block.
Connect the RED wire to the positive (+) terminal of the battery or alternator. WARNING: We highly
recommend that you use a 10A fuse (not provided) to assure that the circuit remains safe and will not be
damaged by excess current.
Connect the BLACK wire to ground, this can be an unpainted metal on the chassis of your vehicle.
Connect the wire harness to the 9-PIN connector located also in the air valves distribution block and then
connect the other end to the control box.
OPERATION
To start using the musical horn set the vehicle's ignition to the ON position.
The 8 buttons in the control box are momentary switches, each one will produce a different tune while is
pressed.
To stop the tune playback release the button.
  • Page 1 1
  • Page 2 2

Vixen Horns VXH6810C Owner's manual

Vixen Horns
Brand
Vixen Horns
Model
VXH6810C
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents