2. Daintree
  3. WTS10
WTS10

Daintree WTS10 Owner's manual

  • Hello! I've reviewed the Override Guide for the GE Current Wireless Thermostat WTS10. This document provides instructions on how to override the auto program and adjust individual mode settings, including heat/cool and fan modes. I'm ready to assist with any questions you may have.
  • How do I activate the display?
    How do I select Heat/Cool or Fan mode?
    How do I confirm the mode settings?
Daintree® Wireless Controls Override Guide
Wireless Thermostat (WTS10)
To override the Auto program:
Press the or button to activate the display.
Press the to raise or button to lower both the
Heat and Cool set points.
Confirm the settings by pressing the middle button.
To change the individual Mode settings:
Press the or button to activate the display.
Press the — button to select Heat/Cool mode; press
the
+
button to select the Fan mode.
Press the or button to select the mode.
When the desired mode appears, press the middle
button to CONFIRM.
Press the button to raise or button to lower the
set point for the currently selected mode.
1
2
3
1
2
3
4
5
1
2
3
1
2
3
4
5
Mode
www.gecurrent.com
T 1-888-694-3533
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are
trademarks of the General Electric Company and are used under license. iBeacon is a trademark of
Apple Inc. Information provided is subject to change without notice. All values are design or typical
values when measured under laboratory conditions.
DT100 (Rev 05/24/21)
/