2. Kensington
  3. K64962EUA
K64962EUA

Kensington K64962EUA Installation guide

  • Hello, I have reviewed the Installation Guide for the Kensington SafeDome Cable Lock for iMac 24". I understand the steps on how to install the cable lock, including attaching the locking plate and securing the dome. I am ready to answer your questions about this product.
  • How do I secure the cable?
    What should I check when attaching the locking plate?
    How do I lock the cable?
    How do I unlock the cable?
SafeDome™ Cable Lock for iMac® 24" Installation Guide
Register your lock at kensington.com/register.
1. Secure the included cable to a fixed anchor point, such as a table leg.
2a. Make sure that the iMac power cable is fed through the iMac cable management cutout, then attach the included locking plate such that
the iMac power cable rests in the notch in the locking plate. The notch should be facing down. When attaching the locking plate to the iMac, it is
important to ensure that the plate is seated properly and that there are no gaps between the plate and the iMac.
2b. Hold the iMac power cable against the notch while pressing the locking plate into the cable management cutout on the iMac. The locking plate tab should be
positioned so that it is facing up.
3. Attach the dome to the locking plate. The power cable cutout on the dome should be facing down.
To lock:Insert the lockhead end of the cable into the dome until it clicks.
To unlock:Insert the key into the lockhead and turn it clockwise 90 degrees. Pull the lockhead out of the dome.
For support, visit kensington.com/support.
/