Instruction manual
7
At this moment you can start to vacuum food:
Note: if you use plastic bag, you do not have to respect the stages above
1. Put plastic bag with the food in the sealing groove (food shall not be more than three-quarters of
the plastic bag).
2. Press mode button (“aliments secs/aliments humides”) once to choose dry (blue light) or twice
wet function (red light), it depends on your food (biscuit or bread is dry food, fish or meat is wet
food).
Note:
• It is recommended to use the continuous device during no more than 20 seconds.
• For the high temperature food packaging, to prevent burns, please cool down after the
packaging.
• The part where you want to seal the bag owes remained clean and exempt from food.
Also watch not to wrinkle the bag
• If you want to put the vacuum-packed food in a microwave, must first punch a hole in the
plastic bag.
• After-party vacuum packaging of food, placed in the refrigerated immediately or froze it.
• Liquid food, it must not be vacuum packed with plastic bag, only need to be sealed.
3. Press the vacuum seal button (“mise sous vide et scellage”): suitable for food which need large
suction force such as cereal.
Or soft seal button (“aliments fragiles”): suitable for food which is lower vacuum degree such as
bread.
Cover is lowered automatically. The vacuum pump is running, the air inside the bag will be
discharged to the outside. Sealing progress light bar allows you to follow the bag sealing.
Note: if you want to stop running, please press stop button. If any dysfunction during vacuum process,
you have just to unplug appliance and try again.
4. Once the vacuum is complete, the green light turns red, the sealing function automatically
activates.
5. After sealing, cover is opened and you can remove the vacuum-packed bags.
External vacuum (button “mise sous vide externe”):
1. To vacuum the food in vacuum canister (not supplied): you have to use supplied vacuum tube
and adaptor with DOM420. You can fix supplied adaptor on specific hole on appliance side and
the other part supplied with your canister have to be fix on the canister.
2. You can press external vacuum button.