Lennox PCO3-14-16, PCO3-16-16 and PCO3-20-16 Ballast Replacement (Y6620) Installation guide

Lennox
Brand
Lennox
Model
PCO3-14-16, PCO3-16-16 and PCO3-20-16 Ballast Replacement (Y6620)
Type
Installation guide
Page 1
AIR CLEANERS / FILTERS
507527-01
4/2018
Supersedes 1/2015
PUREAIR AIR PURIFICATION SYSTEM
PHOTOCATALYTIC OXIDATION (PCO) TECHNOLOGY
INSTALLATION INSTRUCTIONS FOR PUREAIR AIR PURIFICATION SYSTEM
MODELS PCO3-14-16, PCO3-16-16 AND PCO3-20-16 BALLAST REPLACEMENT
BLACK AND WHITE WIRES
WITH RIGHT-ANGLE SPADE
CONNECTORS
BALLAST
CONNECTOR TO
LAMPSOCKET
NEW BALLAST
Shipping & Packing List
Assembled PureAir air purification system which
includes:
Ballast with connectors
Installation instruction
Shipping Damage
Check equipment for shipping damage. If damage is
found, immediately contact last carrier.
WARNING
Risk of property damage, injury, or death.
Installation and service must be performed by a licensed
professional installer (or equivalent) or a service agency.
WARNING
Electric shock hazard.
Can cause injury or death.
Disconnect all electrical power supplies before servicing.
Access panels must be in place during appliance
operation.
CAUTION
Sharp edges hazard.
Sharp edges can cause injuries.
Use protective gloves when grasping equipment edges.
Page 2
Installation
1. Disconnect AC power cord and remove access panel.
2. Rotate control panel out.
ROTATE OUT THE
CONTROL PANEL
ASSEMBLY
DISCONNECT
BALLAST
CONNECTOR
LAMPHOLDER
3. Disconnect the lampholder cable assembly from the
ballast connector.
4. Disconnect the black and white wires with right-angle
spade connectors from the power receptacle.
BLACK AND WIRE WIRES WITH RIGHT-ANGLE
SPADE CONNECTORS
5. Using a 11/32” nut driver, remove the washer nut that
is securing the ballast and two ground ring terminals
(green) to the control panel.
WASHER
NUT
GROUND WIRES (GREEN)
6. Slide the ballast out of the lancing.
7. Install the new ballast by sliding it into the lancing,
8. Secure both the ballast and the two ground ring
terminals (green) to the control panel with the 11/32”
washer nut removed earlier. IMPORTANT: Verify that
both ground ring terminals are secure.
9. Connect the white and black wire with the right-angle
spade connector from the ballast to the power
receptacle.
10. Connect the lampholder cable assembly with the lamp
ballast connector.
11. Close the control panel assembly and then re-install
the access panel.
12. Reconnect the power cord and check the unit
operations using the installation instruction
(507477-01).
13. Dispose of the removed ballast in accordance with
local codes.
  • Page 1 1
  • Page 2 2

Lennox PCO3-14-16, PCO3-16-16 and PCO3-20-16 Ballast Replacement (Y6620) Installation guide

Lennox
Brand
Lennox
Model
PCO3-14-16, PCO3-16-16 and PCO3-20-16 Ballast Replacement (Y6620)
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents