Air Cooler CAC-71
1
1) Always switch off and unplug the appliance from the electrical
outlet BEFORE cleaning and also when not in use.
2) NEVER IMMERSE THE APPLIANCE, POWER CORD AND
PLUG INTO WATER OR OTHER TYPES OF LIQUIDS. Please
refer to the section on “Care and Cleaning”.
3) Close supervision is needed when operating the appliance near
children. Ensure that the power cord does not hang over the
work surface.
4) This product must not be left unattended while it is connected to
the main supply.
5) If it is a detachable power cord, always connect the power cord
to the appliance BEFORE plugging it into the electrical outlet. To
disconnect the appliance, switch off the power on the electrical
outlet before removing the power plug.
6) Do not operate the appliance with a damaged power cord set or
plug. Any repairs should always be carried out by an authorized
service centre.
7) Do not place the appliance on or near a hot gas or electric
burner, a heated oven, or near to easily flammable materials.
8) Do not use the appliance in the outdoors or in a damp area.
9) Do not use this appliance for any purposes other than its
intended use.
10) Always place the appliance on a flat sturdy surface. When
moving it, always take precaution not to touch its hot surfaces.
Extreme caution must be used when moving an appliance that
may contain hot liquids.
11) Use of accessories or equipment not supplied by the
manufacturer may result in damages or malfunction on the
appliance or injuries to the user.
12) This appliance should not be used by people who are physically
or mentally impaired (including children) unless proper guidance
is provided during operation.
General Safety Precautions
2
1. Remote control compartment
2. Operation panel and function display window
3. Wind turner
4. Power cord
5. Water level instruction window
6. Wheel
7. Dustproof filter
8. Water tank
9. Power cord bracket
10. Water tank’s safety knob
11. Ice box
12. Remote controller
Parts Identification
3
Sensor Touch Control Panel and Display
Model
CAC-71
Rated Voltage
220-240V~
Rated Wattage
70W
Frequency
50Hz
Before Using for the First Time
1) Please read these instructions carefully before use and keep
them for future reference.
2) Ensure that the voltage indicated on the rating label corresponds
to the mains voltage.
3) Before using for the first time, remove any protective films or
stickers from the air cooler.
4) Ensure that the power switch is at the “OFF” position when
inserting the plug.
Specifications
Operating Instructions
4
How to Use
When turning on the power for the first time, the buzzer will sound
Bi Bi twice, and then it will enter to the standby mode. At this stage
other keys are invalid except the Power ON/OFF Key.
On/Off Key:
In standby mode, press this key to operate the unit. The power
indicator light will turn on and the unit starts on medium speed as
the default setting. The unit is also equipped with last memory
store. The unit will store the last function set by the user before
turning OFF the unit except the (Timer and Mode) function. To
erase the memory, user need to unplug or switch off the unit from
the power point.
Speed Key:
When the power is on, the default wind speed will be on medium
speed, user can press this key to switch the wind speed according
to their desired speed. The cycle of the wind speed function shown
as per below. The corresponding wind speed indicator will also light
according to the speed setting by the user.
Medium Speed→High Speed→Low Speed→Medium Speed
Timer Key:
In the state of power on, press this key to set the automatic
shutdown timer, each time when the user press this key, the
duration will increase by 0.5 hours. The indicator will displays the
cumulative time (0.5H,1H,2H,4H)：from 0.5 hours to 7.5 hours.
After the timer has been set, the countdown begins automatically
and it will switch off after the desired time which set by the user is
over. There will be no time display on the panel if the user never
set this function.
Ion Key:
Anion function is not activated in the initial starting status. Press
this key to switch on/off the anion function. There will be an
indicator light going on/off corresponding to the user input.
Swing Key:
Press this key to oscillate the wind horizontally. The same key is
also used to stop the oscillation. There will be an indicator light on
the panel, will light on/off corresponding to the user input.
5
Cooler / Humidifier Key:
Cooler / Humidifier function is used to produce cold wind. To
produce the cold wind, the user must add water into the water tank
and then press this key. The indicator light will light on and it takes
about 20 sec to feel the coolness on the wind. For better cold wind,
use the ice-box. (Ice-box description given below)
Note: When the water level of the water tank goes below the lower
level. The pump will automatically switch off and the indicator light
will also go off. There will be continues Bi Bi sound for 10times.
Mode Key
Press this key to select the type mode. There are two modes available.
“Natural Mode” and “Sleeping Mode”. The indicator light will light up as
per the user desired.
Natural Wind
The fan operates with three different type of speed which has
been programed into it. For the 3 different type of speed, there
will be three different type of wind will be delivered by the unit.
The chart below shown the type and the wind delivered by the
unit.
6
Sleep Wind
In this mode the speed will be decreased by a level for every
30 minutes.
High speed：High natural wind for 30 minutes— medium natural
wind for 30 minutes—low natural wind (maintain)
Medium speed：Medium natural wind for 30 minutes—low natural
wind (maintain)
Low speed：Low natural wind (maintain)
Instruction of “ICE-BOX”
The appliance is packaged with two unique “ice-box” for its special
ability of keeping the water cool. It keeps the temperature of the
water lower than the ambience temperature which makes the wind
cooler.
How to use Ice-box
Put the ICE-BOXS into the refrigerator and keep them inside until
they are completely frozen. Place one into the water tank at the rear
side of the appliance. The temperature of the water will be 3~8
°
C,
lower than the ambience temperature and this will be maintained for
4 hours.
The two ICE-BOXS can be re-used continuously.
Replacement of Lithium Battery
This appliance comes with a lithium battery.
When the battery power is exhausted,
replace it with a new battery (CR2032, 3V).
Put a coin into the slot of the battery cover.
Turn it towards the direction of "OPEN" to
open the battery cover. Replace the battery.
Take note of the positions of “+” and “-“ signs
for proper battery placement. Close the
battery cover and turn its slot towards the
direction of “CLOSE” to lock it.
7
Always disconnect the appliance from the electrical outlet before
cleaning.
Never immerse the appliance, power cord and plug into water,
or allow moisture to contact with the appliance.
Wipe the exterior parts of the appliance with a damp cloth or
cleaner. Never use a corrosive cleaner.
Dustproof Filter - Hold the handle of the Dustproof Filter to pull
it out. (If the environment is susceptible to dirt, wash it once in
every one or two months).
If notice that the honeycomb filter is dirty, remove the dustproof
filter first. Then unlock the both honeycomb holder on the top
part of it. Wash or spray the honeycomb by using the clean
running water.
Clean the water tank once a month for best performance and
hygiene purposes. Use a mild detergent for cleaning the water
tank. Wipe the water tank nicely with a soft dry cloth before
placing it back.
Clean the outer cover with mild detergent and soft cloth.
As high pressure exists in the machine, the power has to be
turned off and then pull the plug out for cleaning.
Care and Cleaning
8
/
