ELECTRONIC CONTROL PANEL
A. Indicator LEDs to display the current temperature
setpoint or the Fast Cool function
B. Pushbutton for Temperature setting (short pressure) or
Fast Cool activation (long pressure – 3 sec.)
TEMPERATURE SETTING
Temperature setting pushbutton on the control panel allows
to set desired temperature level, from warmest to coldest.
At each short pressure of the pushbutton, the temperature
setpoint will change (cyclically).
The temperature setting will impact both the refrigerator and
the freezer temperature at the same time.
At first plug-in of appliance, the factory temperature setpoint
is set (middle temperature).
Following table shows setpoints level:
Legend: Led ON Led OFF
FUNCTIONS
Fast Cool
The use of the Fast Cool function is recommended:
- to increase the cooling speed of the refrigerator
compartment when placing a very high quantity of food
within it,
- to maximize the freezing capacity of the freezer
compartment: for this reason you should activate the
Fast Cool function before placing fresh food to be
frozen in the freezer compartment.
To activate the Fast Cool function, press and hold for 3
seconds the pushbutton on the control panel: all the 3
LEDs on the control panel will turn on.
The function is automatically deactivated after:
- 28 hours for appliances with sensor cover (11)
- 48 hours for appliances without sensor cover (11)
The function can be manually deactivated by pressing
and holding the same pushbutton on the control panel
for 3 seconds.
/ "6th Sense" / "Green Intelligence"
The "6th Sense "/ "Green Intelligence" function is
automatically activated when:
• a large amount of food is loaded into the refrigerator
and/or freezer
• the refrigerator and/or freezer door is left open for a
long time
• a prolonged power failure takes place, causing the
internal temperature of the appliance to increase to
values that cannot guarantee safe storage of food.
ECO GREEN (depending on the model)
This function gives best food preservation performance
with the smallest energy consumption possible if there is
a lower amount of food to be preserved in the appliance
(around 5-10% less in comparison with the normal
settings – middle temperature).
When ECO GREEN function is activated only these
compartments should be used in order to have the best
food preservation:
- 2"eco green" areas in the fridge ( indicated by green
stickers)
- 1"eco green" area for storing frozen food (item 4) in
freezer compartment - below the shelf (located on the
lower position).
To active the Eco Green function press the pushbutton
on the control panel to choose the mid-high
temperature, as showed here below:
FREEZING FRESH FOOD
Before placing fresh food to be frozen in the freezer
compartment you should activate the Fast Cool function.
Place the fresh food to be frozen on the freezer
compartment wire shelf.
Avoid direct contact with already frozen food. To freeze the
quantity of food shown on the rating plate, move the freezer
wire shelf to the upper position.
- For appliances with sensor cover (11), place the fresh food
just after activation of Fast Cool. After 28h from activation,
function will turn off automatically.
- For appliances without sensor cover (11), place the fresh
food 24h after activation of Fast Cool. After 48h from
activation, function will turn off automatically.
ABNORMAL APPLIANCE OPERATION
When any failure appears, any LEDs start blinking, it is
necessary to call service.
The appliance will work preserving the food stored.
high temp.
med-high temp.
medium temp.
med-low temp.
low temp.
CA
UKR
ROBG
RUS
HSKCZPLFINDKNSGRIPENLFGBD
PRODUCT SHEET
GB
