YUNEEC OTA User guide

Hello, I have read the user manual for the YUNEEC H520E drone, specifically regarding the OTA update process. The document details how to connect the remote controller, check and download firmware updates for various components, including the drone itself, camera, and gimbal. I'm ready to answer your questions about this process.
How to connect the remote controller to the network?

How do I check for firmware updates?

What is required before updating the drone?

H520E OTA Update.

1. Connect your ST16E to your local network via clicking “wifi icon” the right up position

in the screen.

2. Click the “Version” button, then you can see the firmware versions of all components

3. Click on the “Check for Update” button, the app will check all firmware versions. If the

component need to be updated, a “Download” button will be displayed beside the

component’s name.

4. Click the “Download” button of the component that you want to update. After finishing

downloading, an “Update” button will appear. Click on “Update” to upgrade the

component.

Note:

 Please plug the USB cable between remote controller and OFDM component

before updating the drone, OFDM module, camera and gimbal component.

 Please make sure that a SD card is inserted in the camera.

IMPORTANT:

If the Data Pilot app is unable to get the firmware versions from the “Version” section,

please delete the app and install the new version app from our Website.