2. Minelab
  3. Minelab F3 UXO Countermine Detector Coil Changeover

Minelab Minelab F3 UXO Countermine Detector Coil Changeover Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Minelab Minelab F3 UXO Countermine Detector Coil Changeover Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Instruction F3 UXO Coil Change 4901-0079 rev 2, July 2013
For Technical use only – Refer to Service Manual
To Remove Small Coil
1. Prepare a clean workspace.
2. Remove the Battery Pack and
Endcap from the F3 Detector.
2
3. Remove the six screws holding
the Bulkhead cover.
4. Unplug the Wiring Loom.
5. Remove two upper screws.
6. Slide the Electronics Pack
rearwards.
7. Unscrew the Coil Connector.
8. Remove the Retainer Plug.
9. Remove the Coil Retainer.
10. Pull coil cable out of shafts.
To Connect UXO Coil
11. Fit Coil mounting adapter yoke
3
4
5
7
8
11
9
6
Instruction F3 UXO Coil Change 4901-0079 rev 2, July 2013
For Technical use only – Refer to Service Manual www.minelab.com/aus/countermine/maintenance
20. Connect Endcap and Battery Pack then check and test the
F3 UXO Detector.
12. Thread coil cable through the
shafts. A piece of string can be
used.
13. Mount the coil to the shaft.
14. Fit Coil Cable Pin
15. Connect the Coil cable and fit
the retainer plug.
16. Slide the Electronics Pack back
into place, replace two screws.
17. Carefully connect the Wiring
Loom.
18. Replace cover and insert six
screws.
12
13
14
15
16
17
18
/