Assembly Instructions: 1323-M1L (Ella)

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

PREPARING FOR INSTALLATION

Remove all of the contents from the carton. See the important notes above. Shut off the

poweratthecircuitbreakerandcompletelyremovetheoldxturefromtheceiling,including

theoldmountingstrap.

Approximatelyhalfofthecanopyloop’sexteriorthreadsshouldbeexposed,andthe

canopyloopcollarshouldtsnuglyontothecanopyloop.Removecrystalplate(R),metal

disc(Q)andcanopy(G)andadjusttheheightofnipple(F)andcanopyloop(H)untilthe

desiredheightisreached.

ASSEMBLING THE FIXTURE

Usedecorativenuts(M)toattacharms(N).Bymeasuring,determinethecorrectnumberof

chainlinksneededforproperhangingheight.Ifnecessary,useapairofplierstoopenand

removeanyexcesschain.Attachonechainconnector(K)toeachendofchain(J).Useone

ofchainconnectors(K)toattachchain(J)totoploop(L)andclosethechainconnector.

Feedthexture’swiresupthroughthechain(everythreelinksorso),pullingthewiresuntil

(L)wire;whitetoribbed/white/transparent(N)wire;andgroundtoground(greenorcopper).

Twisttheendsofthewirepairstogether,andthentwistonawireconnector.Makesure

alltwistsareinthesamedirection.Ifthereisnogroundwire(greenorcopper)fromthe

junctionbox,locategroundscrew(E)onmountingstrap(A)andwrapthexture’sground

wirearoundthegreengroundscrew(E).Useascrewdrivertosecuregroundscrew(E)onto

themountingbracket/mountingstrap.Tuckallwiresneatlyintothejunctionbox.

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture. Dry with a lint-free or microber cloth.

For Customer Service, contact

H

I

L

J

K

F

E

D

M

N

Tightlythreadcanopyloopcollar(I)ontocanopyloop(H)tosecurecanopy(G)inplace.

Installtheprovidedhalogenbulb(O)inaccordancewiththexture’sspecications.

Bulb Note: Use a tissue or paper towel to hold the bulb and push the bulb down into the socket. Oils and dirt can cause the bulb life to

shorten.Rubbingalcoholisrecommendedforcleaningthebulbs.Coverbulb(O)withbulbshield(P).

Donotexceedthemaximumwattage.CarefullyhangtheD5andD6crystalstrandsasdepictedabove.HangAAcrystaldrop(T)onto

nial(S).

Yourinstallationisnowcomplete.Turnonthepowerandtestthexture.