Feiss F3278/6ANBZ Installation guide

Feiss
Brand
Feiss
Model
F3278/6ANBZ
Type
Installation guide
1
Installation Instructions for
Woodruff Linear Chandelier
1.0
F3278-6
Chandelier
F3278/6
1
2
1A
3
4
5
Temporarily install the mounting plate to the junction box, mark the anchor hole locations, and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box and screw the anchor screws into the anchors.
Determine the wanted height or look of the fixture with the provided swivel and stems and assemble them by screwing them together. All
the parts may be used alone or used in combination.
Feed the fixture wires through the stem assemblies and screw them onto fixture stems.
Feed the fixture wires through the canopy, canopy plate, washers and nuts, then secure them to the swivels using the provided hex nuts
as shown.
Connect the fixture to a suitable ground with accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box and/or canopy, place the canopy onto the mounting plate studs, and secure it in place by
using the cap nuts.
Install the candle tubes by sliding them over the sockets.
Install the candle followers by placing them on top of the candle tubes.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
6
7
8
9
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
10
11
12
13
STEM ASSEMBLY
CANDLE TUBE
CANDLE
FOLLOWER
12
11
FIXTURE STEM
LAMP
13
HEX NUT & WASHER
CANOPY
ANCHOR
ANCHOR SCREW
CANOPY PLATE
MOUNTING PLATE
SWIVEL
4
5
CAP NUT
Page is loading ...
Page is loading ...
4
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.Feiss.com
© 2018 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Feiss F3278/6ANBZ Installation guide

Feiss
Brand
Feiss
Model
F3278/6ANBZ
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents