1
Installation Instructions for
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white driver wire to the neutral power line wire with a wire nut.
Connect the black driver wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the Allen screw using an Allen wrench.
1
2
3
4
5
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for damp locations.
This product may be dimmed with a low voltage electronic dimmer.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Khloe Wall (LED)
1.2
WB1775_WB1776
W 1775, W 1776BB
Wall
1A
JUNCTION BOX
MOUNTING
PLATE
7
ALLEN WRENCH
8
ALLEN SCREW
9
6
7
8
9
ANCHOR
ANCHOR
SCREW
3
3
5
5