Logitech 910-001105 Installation guide

Looking to convert this info to a 4-up layout so we can print in house and cut into quarters

Logitech Performance MX 8-Button Mouse 910-001105

Quick Set Up Guide

Step 1: Open door on bottom of mouse and remove the unifying receiver.

Step 2: Install the rechargeable battery and close door.

Step 3: Using USB cable included plug into USB port to charge mouse (2 hours)

Step 4: Plug unifying receiver into USB port on system.

Step 5: After mouse has finished complete charge, turn on power and use.

Common Troubleshooting Steps:

Can't find dongle: The dongle is located in the battery compartment on the bottom of the unit. You will

need to remove the dongle before you insert the AA rechargeable battery to power the unit.

No Power: If there is no power to the mouse, insure the included AA rechargeable is installed correctly

(- negative polarity goes in first), and then use the included USB cable to fully charge the mouse before

first use. (2-3 hour charge)

Left Mouse Click doesn't work: These MX performance Mouse were all thoroughly tested to insure

100% functionality including all click functions. If click functions are not working properly please try

reinstalling the mouse drivers.

Reinstall the Mouse Drive (if Using PC)

An outdated or corrupted device driver can cause click issues. You may need to update or reinstall the

mouse driver. To do this, from the Win X Menu, open Devices Manager. Locate Mice and other pointing

devices and then right-click on your mouse driver to open its Properties. Switch to Driver tab > click

the Uninstall Device button.

Learn more at www.logitech.com/performancemx