Pyle PLCM7200 Installation guide

WIRING INSTRUCTIONS

Monitor Hook-up:

Red: 12 Volt+ key ignition controlled should lose power with the car in the off position.

Black: 12 Volt – grounding polarity constant earth ground

Green: Reverse Positive + 12 volt Trigger. This will allow the monitor to auto turn on and show

Cam/AV2 video source upon placing the vehicle in reverse

Yellow RCA AV1: Optional external video input from a DVD or alternate camera system

Yellow RCA AV2/Cam: This is the port that that should run from front to back and connect to the

Camera’s yellow port.

Camera Hook-up:

DC power input has a Male DC connection on one side then a red black wire on opposite side

Red: 12 Volt+ Reverse controlled should send power with the car in reverse.

Black: 12 Volt – grounding polarity constant earth ground

Yellow RCA plug: Direct wire to monitor up front

Download PDF