Koxx KOXX-402 Installation guide

Assembly Instructions for Koxx Unicycles

1. Place the fork upside down in a suitable

(work)stand (or ask another person for help.)

2. Put the rubber slips into the axle retainers

3. Insert the wheel into the fork retainer.

4. Put the remaining rubber pads into the half-

round counterparts of the axle retainer. Put

them opposite to the fork axle retainers on the

axle bearings.

5. Tighten the 4 bolts and nuts. Inflate air into tire,

following pressure specification on tire.

6. Screw in the pedals and tighten them with a

15mm open end wrench. Pedals and crankarms

are marked with L(left) and R(right). Please

mount accordingly.

7. Put in saddle and seatpost. Tighten the seatpost

clamp. Seatpost must be put in to the marker

on the tube at least.

This manual is also suitable for

Download PDF