Ekena Millwork SH36X04X04DE Installation guide

URETHANE SHELF

installation instructions:

screw driver

electric drill

level

pencil

TOOL & MATERIAL

CHECKLIST

IMPORTANT INFO

• It is highly recommended that you paint or nish the shelf with 100% acrylic latex paint before

installing.

• Once installed, you can apply any necessary touch‐-up paint or nish.

• For best results, we recommend installing the metal strip into studs for a more secure hold.

• *Not all urethane shelves include hardware. Purchase claw tooth, keyhole, or other shelf bracket

separately to install correctly.

SAFETY INSTRUCTIONS

Make sure to use the correct tools recommended.

Wear safety goggles.

Follow adhesive, power tools, and paint manufacturers’ instructions and users manuals.

Use common sense and follow good construction practices.

1. Position the shelf on the wall and mark the placement with a pencil using the

top line of the shelf.

2. Measure the metal strip 1 to 1 1/4” below your pencil mark. Use the wall

anchors and screws to secure the metal strip (piece not attached to the shelf)

to the wall. Make sure your installed metal strip is level.

3. The shelf is afxed to the wall by positioning the shelf over the metal strip

sliding it down. The shelf bracket and metal strip will interlock holding the

shelf rmly to the wall.

WALL

the interlocking brackets slide

together for a secure hold.

We Can Help. Call (866) 607-0453

www.ekenamillwork.comIndustry leading manufacturer of urethane, PVC, wood, rustic, and metal millwork

flat shelf

corner shelf