producer registration number
WEE/KC33512Q
Remove the protective paper backing from the base of the skimmer and any
transportation tape from the skimmer body
Insert the vibration absorbing rubber feet into the base plate.
Insert the air hose from the air intake to the air silencer.
Install the collection cup into the neck of the skimmer, turning gently
clockwise to lock the cup in position (avoid over tightening).
For the best results place the skimmer in 22 - 25 cm of water. Please make sure that the
skimmer is in no more than 25.5 cm of water as the gate valve will not operate properly.
The pump must be completely submerged underwater when in use.
Plug the pump into the power outlet and switch on.
The main chamber will ll with bubbles; adjust the gate valve until the water level is
where the collection cup meets the neck. If a wet skimmate is preferred slowly turn the
gate valve clockwise (to close). Otherwise, turn the gate valve anticlockwise for a drier
skimmate.
Please open the package carefully and check for damaged or lost parts.
Main skimmer body, collection cup, lid and air silencer.
Gate valve, airline and rubber feet.
Extreme 3.0 Needle wheel pump.
Never connect the AFM Marine Extreme PSK-S3.0 Needle Wheel Protein
Skimmer (product) to the power outlet whilst your hands are wet.
Do not allow the pump to run dry. Keep the pump submerged during operation.
Failure to do so could damage the pump and or cause failure.
Ensure that there is a drip-loop in the pump cord to prevent water running down
the cord and reaching the plug/power outlet.
Always unplug the product from the power outlet prior to the product
maintenance.
While we take great care to keep any contaminates away from our products during
manufacture please take a moment to clean the protein skimmer and plumbing
before use. (only clean your protein skimmer with warm water; never clean with
any soap or chemicals and use caution when handling as acrylic scratches easily)
For best performance, please clean the collection cup frequently using a sponge and
warm water.
Regular maintenance of the pump will ensure a long life and maximum performance.
AFM Marine warrants this AFM Marine product to the original purchaser against
defective material and workmanship that occurs during normal non-commercial
use for 12-months from the date of purchase.
The Company will at its discretion, either repair or replace same without charge.
Said warranty is limited to replacement or repair of product only and does not
cover loss of aquarium life, personal injury, property loss, or damage arising from
use of the product. Original proof of purchase is required to validate warranty.
Exclusions:
a. Damage resulting from accident, misuse, lack of reasonabe care, subjecting the
product to abnormal working conditions or any other failure not resulting from
defects in materials or workmanship.
b. Damage resulting from modication, tampering with or attempted repair by
anyone other than the Company.
c. Transfer of the product to someone other than the original consumer or
purchaser.
What You Must do to Enforce Warranty:
Your rst point of contact is the retailer the product was purchased from; in the
unlikely event that you the end user remain dissatised please email us at
/
