8
Chapter 2: Safety Instructions
CAUTION!
You may be subjected to severe electrical shock if you disassemble the Smart Safe.
THE WORKING TEMPERATURE OF THE DEVICE IS FROM 0 °F TO 122 °F.
KEEP PRODUCT SURFACES CLEAN AND DRY. TO CLEAN THE OUTSIDE CASE OF THE SAFE, USE
A LIGHTLY DAMPENED CLOTH. DO NOT USE CLEANING SOLUTIONS OR SOLVENTS.
NEVER INSERT METAL INTO THE SAFE’S CASE OR ITS OPENINGS. INSERTING METAL INTO THE
SAFE’S CASE MAY CAUSE ELECTRIC SHOCK.
PLEASE MAKE SURE YOU HAVE A STRONG WI-FI CONNECTION IN THE LOCATION WHERE YOU
PLAN TO INSTALL THE DEVICE.
DO NOT EXPOSE THE SAFE TO RAIN OR USE NEAR WATER. IF THE SAFE GETS WET, REMOVE
THE BATTERIES AND CONTACT TECHNICAL SUPPORT IMMEDIATELY.
DO NOT INSTALL THE SAFE NEAR ANY HEAT SOURCES SUCH AS STOVES, HEAT REGISTERS,
RADIATORS OR ELECTRONICS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.
ALL ELECTRONIC OPERATION SHOULD BE IN STRICT COMPLIANCE WITH THE ELECTRICAL
SAFETY REGULATIONS, FIRE PREVENTION REGULATIONS AND OTHER RELATED REGULATIONS IN
YOUR LOCAL REGION.
WHEN MOUNTING THE SAFE, MAKE SURE IT IS FIRMLY FIXED TO THE SURFACE.
IF SMOKE, ODORS OR NOISE RISE FROM THE DEVICE, TURN OFF THE POWER AT ONCE BY
REMOVING THE BATTERY PACK.
NEVER ATTEMPT TO DISASSEMBLE THE DEVICE YOURSELF. (WE SHALL NOT ASSUME ANY
RESPONSIBILITY FOR PROBLEMS CAUSED BY UNAUTHORIZED REPAIR OR MAINTENANCE.)
DO NOT DROP THE DEVICE OR SUBJECT IT TO PHYSICAL SHOCK, AND DO NOT EXPOSE IT
TO HIGH ELECTROMAGNETISM RADIATION. AVOID INSTALLING ON A VIBRATING SURFACE OR
PLACES SUBJECT TO SHOCK (IGNORANCE CAN CAUSE EQUIPMENT DAMAGE).
DO NOT OPERATE IN WET OR DUSTY AREAS. AVOID PLACING THE SAFE IN AREAS SUCH AS A
DAMP BASEMENT OR DUSTY ATTIC.