Shadow SH945 NFX-V Tonabnehmer für Violine Installation guide

Type
Installation guide

This manual is also suitable for

Installation Instruction for SH 945 NFX
NANOFLEX Violin Pickup System
Content:
Nanoflex pickup with shielded cable and 2.5mm plug
Control unit with holder and 6.3mm output jack
3-Volt battery
1. Loosen strings, so that the bridge can be raised a few millimeters easily.
2. Do not alter the pickup. Lift bridge up. Place pickup between bridge feet and body so that the cable
points toward the tailpiece of the instrument (see Fig. 1).
3. The pickups has to be centered under the feet to guarantee optimized sound transfer. Take care,
that there is no unevenness/roughness (dirt, dust, concavities on top of instrument or bottom of
bridge).
4. Tune your instrument.
5. Install the control unit on an suitable place between chinrest holder and F-holes on the left side of
your instrument. The installation principle is the same as on your chinrest holder.
6. Place supplied 3V battery into control unit. Note correct polarization.
7. Plug pickup-cable into the 2.5mm input jack of the control unit.
8. Connect to appropriate amplifier with instrument cable.
Pickup
Pickup Cable
Fax: (561) 743 0460
eMail: USA@shadow-electronics.com
Shadow Electronics of America Inc.
17791 Alexander Run
Jupiter, FL 33478 U.S.A.
Shadow Elektroakustik
Peter-Haendel Straße 2
91334 Hemhofen · Germany
Fax: +49 - 91 95 - 92 99 30
eMail: info@shadow-electronics.com
For more information please check: http://www.shadow-electronics.com
  • Page 1 1

Shadow SH945 NFX-V Tonabnehmer für Violine Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI