Content: sound hole pickup, endpin, battery holder
1. Loosen strings and remove original strap nut.
2. Increase original hole up to 13mm diameter.
3. Remove strapt nut, hexagon nut and washer from the endpin.
4. Plug the pickup cable into the endpin.
5. Adjust the inside nut so the larger diameter threads on the endpin stop slightly under the outside
of the guitar.
ATTENTION: The larger thread has to end inside the frame of your guitar (see fig. 2).
Put the washer from the outside on the endpin jack, tighten the hexagon nut by means of a wrench
and screw new strap nut on.
Frame
6 . Remove the tape from the pickup-cable-holder and stick it on the inside of the guitar
to avoid cable noises.
7. Install the pickup into the sound hole by loosing the screws, place the holder under the top of the
guitar and tighten the screws.
8. Tune your guitar.
Fig. 2
Fig. 1
Fax: (561) 743 0460
eMail: [email protected]
Shadow Elektroakustik
Peter-Haendel Straße 2
91334 Hemhofen · Germany
Shadow Electronics of America Inc.
17791 Alexander Run
Jupiter, FL 33478 U.S.A.
Fax: +49 - 91 95 - 92 99 30
eMail: [email protected]
Installation Instruction for SH 141
Active Magnetic Sound Hole Pickup
Endpin
Strap Nut
Washer
Inside Nut
Hexagon Nut
Top of Guitar
Guitar bottom
/
