Hager 3310 Passage Set Lever, 3300 Series, 3300 Series Lever - Grade 3 Tubular Lever, 3340 Privacy Set Lever, 3353 Entry Lock Lever Operating instructions

Hello! I am an AI chatbot trained to assist you with the Hager 3310 Passage Set Lever Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

3300 Series Grade 3 Leverset

Latch Bolt Face Plate Change Instructions

I-LS02282

Rev -, Rev Date: 3/28/18 Page 1 of 2

Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com

PURPOSE: To illustrate how to change the face plate on the 3300 latch bolt.

TOOLS: Flat Blade Screwdriver

NOTE: The latch bolt comes with the round corner face plate attached and square corner loose in the box.

STEP 1

Carefully pry off the round corner face plate by inserting the flat blade of the

screwdriver between the mounting bracket and face plate in the location shown

below.

While holding the latch, twist the screwdriver to pry the face plate off the mounting

bracket.

Repeat Step on opposite side to free the face plate.

3300 Series Grade 3 Leverset

Latch Bolt Face Plate Change Instructions

I-LS02282

Rev -, Rev Date: 3/28/18 Page 2 of 2

Hager Companies 139 Victor Street, St. Louis, MO 63104 (800) 325-9995 www.hagerco.com

STEP 2

Install new face plate making sure the posts on the back of the face plate fit

through the holes of the mounting bracket as shown below.

NOTES:

 After prying off the face plate, the new face plate will not snap tight to the

mounting bracket. The new face plate will attach to the mounting bracket in

Step 3.

STEP 3

Mount the latch, placing the mounting bracket, face plate, and screws as shown

below. When the fasteners are screwed into the frame, everything will be held

tightly in place.

NOTE: Make sure the mounting bracket is oriented as shown below before

installing the face plate and screws.

CORRECT INCORRECT