Varney Tools 032929 Operating instructions

Instruction for Footer Layout:

1. Drive ½” rebar stake (stake 1) at desired location.

2. Place Footer Square on to stake.

3. Attach line-string to outside groove of Footer Square ensuring proper length of line-string for

footer layout.

4. Pull line-string to desired distance. Keeping line-string lined up with Footer Square groove. When

line-string is lined up with the groove, drive stake 2.

5. Repeat step 4 for stake 3.

6. Measure proper distance from stake 2 and 3; drive stake 4.

7. In order to ensure footer is square measure diagonally as close to the ground as possible from

stake 1 to stake 4 then measure from stake 2 to stake 3. Measurement should be equal.

Instruction for Footer Angle Layout:

1. After layout of basic footer attach line string to the stakes.

2. Attach line-string to the 45 degrees side of Footer Square ensuring proper length of line-string for

the angle layout.

3. Place pivot corner of the Footer Square on top of the line-string at the proper location. Turn

Footer Square to the desired angle on the same string that the pivot corner is placed.

4. Pull line-string that is attached to Footer Square to the proper distance, keeping line-string lined

up with the groove on the footer square. Then drive stake.

Download PDF