2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. PAC
  6. CM-1

PAC CM-1 User manual

  • Hello! I am an AI chatbot trained to assist you with the PAC CM-1 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
[email protected] • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com
CM1
Chime Module
For the OS-2 or
OS-2BOSE Interface
OS2-RAD
1
9
10
18
12
CM1
General Motors Class II Chime Module
Pacific Accessory Corporation • Santa Ana, CA 92705
Must be used with the OS-2 or OS-2BOSE Interface
Yel - Constant +12volts
Blk - Chassis ground
Org - To OS-2 or
OS-2BOSE
+12volts
To pin# 12
CM1 Installation Instructions:
Unplug the OS2-RAD cable from the interface
prior to wiring the CM1.
1. Connect the CM1’s BLACK wire to the OS2-RAD BLACK wire.
2. Connect the CM1’s YELLOW wire to the OS2-RAD YELLOW wire
3. Insert the CM1’s ORANGE wire with the MOLEX pin into
pin location #12 of the OS2-RAD (18 pin) MOLEX plug.
Do not use force! Pin will snap in with minimal effort, if inserted
correctly.
4. Plug the OS2-RAD plug back into the interface .
5. When first powered up, the CM1 will chime one time to indicate
proper power connection. All warning chimes are now retained.
6-15-06
Pacific Accessory Corporation
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
[email protected] • Voice: 714-835-3022 • Fax: 714-835-3233 • www.pac-audio.com
CM1
Chime Module
For the OS-2 or
OS-2BOSE Interface
OS2-RAD
1
9
10
18
12
CM1
General Motors Class II Chime Module
Pacific Accessory Corporation • Santa Ana, CA 92705
Must be used with the OS-2 or OS-2BOSE Interface
Yel - Constant +12volts
Blk - Chassis ground
Org - To OS-2 or
OS-2BOSE
+12volts
To pin# 12
CM1 Installation Instructions:
Unplug the OS2-RAD cable from the interface
prior to wiring the CM1.
1. Connect the CM1’s BLACK wire to the OS2-RAD BLACK wire.
2. Connect the CM1’s YELLOW wire to the OS2-RAD YELLOW wire
3. Insert the CM1’s ORANGE wire with the MOLEX pin into
pin location #12 of the OS2-RAD (18 pin) MOLEX plug.
Do not use force! Pin will snap in with minimal effort, if inserted
correctly.
4. Plug the OS2-RAD plug back into the interface .
5. When first powered up, the CM1 will chime one time to indicate
proper power connection. All warning chimes are now retained.
6-15-06
Pacific Accessory Corporation
/