Pacifi c Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
www.pac-audio.com Voice: 714-835-3022 Fax: 714-835-3233 [email protected]
Page 1
7-20-2006
Prior to installation, make sure your vehicle charging
system is at least 13.8 volts when the vehicle is started and
running.
1.
2. Mount the Tricolor LED by drilling a 1/4” hole in mounting
location and insert the LED from behind through the
hole. Insert the black bezel onto LED and snap both
pieces back into the hole until bezel is fl ushed against
the mounting location.
Installation
Operation
• Gives you visual indication of a charging system before
you get stranded.
• Automaticly turns off Load Control Output circuit if voltage
drops below 11.5v
BG-12
Battery Monitor
Mobile Audio Interfacing Equipment
RED: +12v Accessory Input
BLACK: Ground
ORANGE: Dimming Control Input
YELLOW: +12v Ignition Input
YELLOW/BLACK: Load Control Output
( .5 amps max, use a relay)
If the ORANGE wire (Dimming control Input) is connected
the TRI-color LED will dim to reduce the brightness when
the parking lights are on.
LED Color Indication:
RED: Below 11.5v
YELLOW: Between 11.5v and 12.4v
GREEN: Above 12.4v
BG12
Battery Gaurd
Pacific Accessory Corporation, Santa Ana, CA 92705
(+)12v Accessory
(+)Dimmer Input
(+)Load Control Output
YELLOW (+)12v Ignition Input
BLACK (-)Chassis ground
ORANGE
RED
YEL/BLK
TRI-Color LED
Red = below 11.5v
Yellow = between 11.5 and 12.4
Green = above 12.4v
-
1
