2. Computers & electronics
  3. TVs & monitors
  4. Flat panel wall mounts
  5. Mircom
  6. LT-975 RB-MD-952

Mircom LT-975 RB-MD-952 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Mircom LT-975 RB-MD-952 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
LT-975 Rev 0
September 2009
Model RB-MD-952
Replacement LCD Display & Keypad
Installation Instructions
RB-MD-952 Mounting
Unscrew the eight #8-32” locknuts that hold the existing board in place. Disconnect cable from main entry panel board
and remove the display from the front door of the entry panel. Replace with new board RB-MD-952 connect the cable
and use the eight locknuts to mount the replacement board in place.
Figure 1: RB-MD-952 Board Replacement
The eight
locknuts
holding the
LCD and
board in
place.
T
o replace the 8 x 20 LCD
unscrew the 8 locknuts on the
board and disconnect the
ribbon cable from the entry
main controller board. Replace
with the RB-MD-952 board,
re-connect the ribbon cable and
fasten with the 8 locknuts.
/