Page is loading ...
1
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY AND KEEP THEM FOR ALL
FUTURE USES
When using an electrical appliance, the following basic safety
precautions should be followed:
Before using it, check that the power of the voltage corresponds
to that indicated on the rating plate of the appliance.
Do not leave the cord hang from the edge of a table or a counter.
Do not use any appliance with a damaged cord or plug.
If the power cable is damaged, it must be replaced by the
manufacturer or its representative or another qualified person to
avoid any risk of danger.
Avoid any contact with moving parts.
It is not recommend to use accessories as a glass bowl, a lid, etc.,
which may cause fire, electric shock or injury.
The appliance can not be used to mix hard and dry substance,
otherwise, the blade could be blunted.
Turn off the appliance and unplug it from the electrical outlet
before changing any of its accessories or approaching the parts
that are movable during the operation.
Do not immerse the engine block in water or other liquids.
Do not use it outdoors.
Always disconnect the appliance from the power supply if it’s
left unattended and before the assembly, the disassembly or the
cleaning.
This appliance can be used by persons whose physical, sensory
or mental capacities are limited or whose experience or
knowledge is insufficient, as long as they are supervised or
instructed to use the appliance safely to the extent that they
2
understand the potential dangers.
Children should not use the appliance as a toy.
Precautions should be taken when handling sharp blades, when
you emptying the bowl and during cleaning.
How to clean surfaces in contact with food is defined in
"CLEANING AND MAINTENANCE".
Be vigilant if a hot liquid is poured into the blender that it can
be ejected from the appliance due to a sudden boiling.
This appliance must not be used by children. Keep the appliance
and its cable out of the reach of children.
The continuous use time is 2 min maximum. Leave the appliance
rest for at least 1 minute before re-using it.
Speed
adjustment
Use
Position 1,2,
For a light mix of liquids
Position 3,4
For a stronger consistency - for mixing thicker
liquids and foods; ;
Position Pulse
(P)
To crush ice and produce powerful pulse
movements
( The switch does not remain on the 'Pulse' setting.
You must hold the switch at the 'Pulse' setting or
turn it repeatedly).
3
CLEANING AND MAINTENANCE
Motor Base
Never immerse the engine block in water.
Wipe it only with a damp cloth.
Simple cleaning / rinsing the glass bowl
Empty the glass bowl and fill it with water. Put the glass bowl on
the motor block and turn the switch for several times to the 'P'
setting for a few seconds. Drain the water from the glass bowl and
rinse it until it is clean.
Be careful when handling the cutting blades.
Attention: Never disassemble the bowl from the holder
which it is attached to.
DESCRIPTION
1. Measuring cap
2. Lid
3. Glass bowl
4. Base
5. Rotary switch
(Pulse,0,1,2,3,4)
4
INSTALLATION
Before first use
All blender parts must be thoroughly cleaned before being used for the first time (see
the paragraph on Cleaning and Maintenance).
Setting up the glass bowl
1. Make sure the blender is off (the switch is in position '0')
2. Put the bowl on the base (4), positioning it according to the drawing below.
USE
1. Insert the desired food into the glass bowl:
2. Put the lid on the glass bowl and close it carefully. The tightness should be
guaranteed.
5
3. Functions of the Rotary switch (5)
4. When the operation is complete, always turn the switch back to '0' and unplug the
power cord. To remove the glass bowl, lift it off from the base.
The continuous use time is 2 min maximum.
Leave the appliance rest for at least 1 minute before re-using it.
Helpful Tips
1. If you want to grind solid foods (only ripe fruit), first cut them into small pieces (2
to 3 cm) and then insert them progressively through the opening of the bowl lid.
2. Always put your hand on the lid of the blender during operation.
3. Do not put hot liquids in the blender.
4. To mix thick liquids, we recommend that you use the blender in pulse mode to
prevent the blades from locking.
Speed adjustment
Use
Position 1,2,
For a light mix of liquids
Position 3,4
For a stronger consistency - for mixing thicker liquids and
foods; ;
Position Pulse (P)
To crush ice and produce powerful pulse movements
( The switch does not remain on the 'Pulse' setting. You must
hold the switch at the 'Pulse' setting or turn it repeatedly).
6
220-240V ~ 50/60Hz 600W
Model: CY-311G
Ref: CEBL15IX6
LOT #: 062019
- Electrical and electronic equipment should be selectively collected.
- Do not throw waste electrical and electronic equipment with unsorted municipal
waste, but carry out their selective collection.
amc
Continental Edison
120-126 Quai de Bacalan
CS 11584
33000 Bordeaux
A.M.C.
123, QUAI JULES GUESDE
94400 VITRY SUR SEINE
France
IMPORT BY:
/