Prorack X8
The Prorack X8 is a universal crossbar system that can be fitted to most vehicles with side rails. It is designed to carry a wide range of loads, including kayaks, bikes, fishing rods, skis, and snowboards. The X8 is made from high-quality materials and is built to last.
Here are some of the features and benefits of the Prorack X8:
- Easy to install: The X8 can be installed in minutes without any tools.
- Versatile: The X8 can be used to carry a wide range of loads, making it a great choice for outdoor enthusiasts.
- Durable: The X8 is made from high-quality materials and is built to last.
Prorack X8
The Prorack X8 is a universal crossbar system that can be fitted to most vehicles with side rails. It is designed to carry a wide range of loads, including kayaks, bikes, fishing rods, skis, and snowboards. The X8 is made from high-quality materials and is built to last.
Here are some of the features and benefits of the Prorack X8:
- Easy to install: The X8 can be installed in minutes without any tools.
- Versatile: The X8 can be used to carry a wide range of loads, making it a great choice for outdoor enthusiasts.
- Durable: The X8 is made from high-quality materials and is built to last.
,OADSOFADVENTURE
Page 1 of 3
,OADSOFADVENTURE
X-BAR UNIVERSAL INSTRUCTIONS
Assembly Instructions for Universal X-Bar (X8)
Fitting Instructions
Using a key, unlock and remove
the locking covers from the leg
assemblies.
Kit contains:
2 x crossbars
4 x leg assemblies
4 x clamps
2 x keys
Fit the clamp to the leg. Fit the leg and clamp assembly to the
vehicle side-rail taking care to hold the
adjustment screw clear of the rail.
Fit the plastic nut onto the adjustment
screw and swing it down under the
clamps. Tighten the nut until the clamp
just touches the underside of the side-
rail.
Repeat the first four steps for the other
three legs in the approximate position
shown.
Slide the crossbars through the legs
and even up the amount of crossbar
that protrudes through the legs on both
sides of the vehicle.
1 x hex key
4 x plastic nuts
Contact your Prorack dealer if any parts are missing.
600 - 1200mm
Page 2 of 3
,OADSOFADVENTURE
X-BAR UNIVERSAL INSTRUCTIONS
Using the hex key, tighten up the 2
screws in each leg at the rear, taking
care to tighten both sides evenly.
Fully tighten the plastic nut at the front
of the leg.
Slide the covers onto the legs.
Important Instructions for Use
The rack is by design, a safe product. Unfortunately, the use, application
and operation of the rack system is outside Prorack’s control and must
therefore be your responsibility. When fitted and used correctly and
maintained adequately, this rack will provide many years of dependable
service.
The following list provides an effective check to ensure all loads are correctly
mounted on the rack.
Check the tightness of the screw attachments regularly, especially after •
traveling on rough surfaces. Also check attachments after first couple of
uses after newly assembled.
Spread the load evenly across and between the bars.•
Maximum loads: 60kg (30kg per bar)•
Load should not overhang sides of the roof rack.•
Ensure all loads are securely fastened. Check regularly during longer •
journeys.
Lock, using the key.
Page 3 of 3
,OADSOFADVENTURE
X-BAR UNIVERSAL INSTRUCTIONS
Kayak holder•
Cycle holder•
Fishing rod holder•
Ski holder (lockable)•
Universal ski holder•
Aerodynamic roof boxes•
Snowboard holder (lockable)•
Available Accessories
Hubco Automotive Ltd
46 Parkhouse Road
PO Box 11-017
Christchurch 8004
New Zealand
Freephone New Zealand:
0800 4776 722
Freephone Australia:
1800 143 548
Warranty & Disclaimer
Where the product is supplied to the customer for other than business purposes within the 1.
meaning of section 43 of the New Zealand Consumer Guarantees Act 1993, the provisions of that
Act shall apply. It is important that anyone who fits or uses this product does so in accordance
with the manufacturers instructions.
Where the product is supplied to the customer for business purposes within the meaning of 2.
section 43 of the New Zealand Consumer Guarantees Act 1993, the provisions of that Act shall
have no effect and the clauses below shall apply. Where the product is supplied and purchased in
Australia, the following shall apply:
THE SUPPLIER WARRANTS the product to be free from defects in materials and/or a)
workmanship for a period of two (2) years from the date of original purchase (the warranty
period). Proof of purchase is required. Subject to the limitations and exclusions set out below,
the Supplier hereby agrees to remedy any defects in materials or workmanship becoming
apparent during the warranty period, by replacing or repairing any defective product or
component (at its option) free of charge to the purchaser in respect of replacement parts or
labour. Any defective product or component must be notified and where practicable, returned
at the purchaser’s expense to the Supplier immediately upon discovery of the alleged defect
and no attempt made on the part of the purchaser to repair it.
EXCEPTIONS, EXCLUSIONS AND LIMITATIONS TO WARRANTY. The product and/or its b)
components must be fitted/assembled in accordance with the Supplier’s written instructions.
This warranty does not cover defects, loss or damage resulting a circumstances beyond the
Supplier’s control including, but not limited to misuse, overloading, or failure to assemble
and/or fit the product or component in accordance with the Supplier’s written instructions.
Nor does the warranty cover defects, loss or damage resulting from accidents, unlawful use
of the vehicle or defects/inconsistencies in the vehicle on which the product or component
is fitted. Liability for direst, indirect, special, punitive, incidental, exemplary, contractual or
consequential damage or loss arising from defects, faulty materials or design omissions or
negligence or workmanship in the product or its components is hereby expressly excluded.
Certain Commonwealth legislation, including the Trade Practices Act 1974, and other State
and Territorial legislation confers upon purchasers rights which cannot be excluded from
or be restricted or modified by contract. Any conditions, guarantees and/or warranties
implied by law and incapable of exclusion are deemed to be expressly incorporated herein.
Nothing herein contained is intended nor shall be permitted to be inconsistent with any such
conditions, guarantees and/or warranties. To the extent permitted by legislation all conditions,
guarantees and/or warranties such as implied warranties which are capable of exclusion are
hereby expressly excluded and negatived.
A loaded rack system can alter the performance of your vehicle. Be •
especially aware of the effects of cross-winds, changes in direction and
braking performance. Avoid rapid acceleration and deceleration. Drive
carefully.
When carrying long loads, such as canoes or pipes, always use the •
appropriate accessory and tie the front and back of the load to the “tie-
down hooks” supplied with the accessory, to avoid the load being lifted
by the airflow.
If the load overhangs the rear of the vehicle, tie a flag at the rear end of •
the load to improve visibility for the following vehicles.
On vans and wagons ensure tailgate opens clear of rear of load.•
-
1
-
2
-
3
Prorack X8
The Prorack X8 is a universal crossbar system that can be fitted to most vehicles with side rails. It is designed to carry a wide range of loads, including kayaks, bikes, fishing rods, skis, and snowboards. The X8 is made from high-quality materials and is built to last.
Here are some of the features and benefits of the Prorack X8:
- Easy to install: The X8 can be installed in minutes without any tools.
- Versatile: The X8 can be used to carry a wide range of loads, making it a great choice for outdoor enthusiasts.
- Durable: The X8 is made from high-quality materials and is built to last.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Prorack X9 Operating instructions
-
-
-
-
-
-
-
-
-
Other documents
-
Warrior Products 832 Installation guide
-
Rhino Rack RHINO-RACK 570 Side Loading Kayak Carrier User manual
-
Rhino-Rack Vortex RLT600 Trackmount 2-Bar Roof Rack Installation guide
-
Rhino-Rack 572 Installation guide
-
-
-
-
Rhino-Rack 3-Bar Backbone Roof Rack Installation guide
-
Rhino Rack RHINO-RACK RX100 RX Raised Leg Kit Operating instructions
-
