2. Stratco
  3. Multi-Purpose Utility 2 Door Metal Cabinet

Stratco Multi-Purpose Utility 2 Door Metal Cabinet Operating instructions

  • Hello! I've reviewed the assembly guide for the STRATCO HT-6401 Utility Cabinet. This document provides detailed, step-by-step instructions on how to assemble your new 2-door metal cabinet, including how to fit side, front, top and bottom panels, how to add shelves and the middle divider. The guide also has important information about safety and the risk of toppling furniture. I'm ready to assist with questions you may have about the assembly process or the cabinet's features.
  • What safety measures should I take during assembly?
    What is the weight limit for each shelf?
    How can I prevent the cabinet from tipping over?
Each shelf can hold a maximum load of 45kg.
Please carefully read and follow these instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
1
Slot front door panel into
one side then into the other.
Note: Ensure the front door
panel is flush with the side
panels. This is easier to do
with the doors open.
Screw together
back panel
and right hand
side panel
at locations
indicated by
the arrows.
Screw together
back panel
and left hand
side panel
at locations
indicated by
the arrows.
FITTING SIDE
PANELS TO
BACK PANEL
FITTING FRONT
DOOR PANELS
TO SIDE PANEL
Step 1
Step 2
FITTING THE
TOP PANEL
Step 3
A
C
B
EScrew the top panel to
the inside of the cabinet
as indicated by the arrows.
DSlide the top panel inside
the cabinet until flush
with the top of panels.
2 DOOR METAL
UTILITY CABINET H T- 6 4 01
JUNE 2023
WARNING: SERIOUS INJURY CAN BE CAUSED BY TOPPLING FURNITURE. To help
prevent tip-over, we recommend you anchor this product to a wall or other suitable surface. Check anchors regularly.
Finished size:
1850mm high x
900mm wide x
450mm deep.
C
M
Y
CM
MY
CY
CMY
K
2
H T- 6 4 01
Finished size:
1850mm High
1000mm Wide
500mm Deep
FITTING THE
BOTTOM PANEL
TO THE CABINET
Step 4
FITTING THE MIDDLE
DIVIDER PANEL
Step 5
FITTING SHELVES
RHS SIDE
Step 6
Push the floor panel down
inside the cabinet ensuring
the sides of the floor slide
into the slots on the side
and back panels.
Place shelf inside cabinet,
ensure it slides into slots
in panels.
Fit coat hanger rod as shown.
Insert the
middle
divider
panel and
ensure
both top
and bottom
edges
slide into
slots in top
and floor
panels.
Secure the
panel with
screws as
indicated.
F
H
J K L
M
I
G
FITTING
SHELVES
LHS SIDE
Step 7
To fit a shelf, four shelf supports need to be placed at equal
heights around the inside of the cabinet. The shelf supports
fit in as shown in Figure J, K and L.
Place shelves on
pre-positioned
shelf supports.
2 DOOR METAL
UTILITY CABINET
JUNE 2023
/